Δεχόμαστε κρυπτονομίσματα — έτσι ώστε αυτά που κατέχετε να μπορούν να αγοράσουν πραγματικό εξοπλισμό.Πληρώστε σε κρυπτονομίσματα, ξοδέψτε τα σε πραγματικό εξοπλισμό. Δωρεάν ασφαλισμένη αποστολή παγκοσμίως άνω των 399 $. Ουδέτερες κούτες αποστολής, χωρίς σήμανση, από τη Γερμανία.Δωρεάν ασφαλισμένη αποστολή άνω των 399 $. Η ισοτιμία σας κλειδώνει για 30 λεπτά μόλις ανοίξει το ταμείο.Κλείδωμα ισοτιμίας 30 λεπτών. Κάθε προϊόν είναι σφραγισμένο, ελεγμένο ως προς τον σειριακό αριθμό του, και καλύπτεται από εγγύηση 24 μηνών.Σφραγισμένο, με εγγύηση 24 μηνών.

Παρακολουθούμενα είδη Σύνδεση

KHACHIMO

KHACHIMO TDR-960-24 24V 40A power supply

SKU CH-D8XH-XCBXE

Delivers 24V at 40A for 960W in an ATX form factor, tested working

  • TypeATX
  • Delivers 960 W continuous power for demanding 24 V systems
  • Provides 40 A output current to drive high-load equipment reliably
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good quality components

KHACHIMO TDR-960-24 24V 40A unit

This KHACHIMO power supply delivers 24 V at up to 40 A for industrial or test-bench use. It is built as an ATX-type switch-mode unit and has been test-verified for reliable operation. Buyers needing a different output voltage or a redundant hot-swap design should look elsewhere.

960 W capacity and headroom

The 960 W rating gives comfortable headroom for loads drawing up to the full 40 A at 24 V. Continuous operation at the maximum current is supported, but sustained loads beyond that rating will trigger protection or shutdown. Systems requiring higher peak power or multiple isolated rails are not suited to this single-output model.

Βασικά χαρακτηριστικά

  • Delivers 960 W continuous power for demanding 24 V systems
  • Provides 40 A output current to drive high-load equipment reliably
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good quality components

Προδιαγραφές

TypeATX

Ερωτήσεις για αυτό το προϊόν

Will the KHACHIMO TDR-960-24 fit in my existing ATX case?

Yes, the unit follows the ATX form factor so it mounts in standard ATX chassis and uses the same screw pattern as older ATX supplies.

How can I verify the 24V 40A output is stable after installation?

Measure the DC output with a multimeter under load; it should read close to 24 V and deliver up to 40 A without shutting down.

Επίσης σε αυτό το ράφι

Οι πελάτες σύγκριναν και αυτά

Ίδιο ράφι, ίδιο ταμείο — οκτώ νομίσματα και κλείδωμα ισοτιμίας 30 λεπτών.