Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.

Uzraudzītās preces Pieteikties
Silver rectangular ATX power supply unit with ventilation grilles and rear connector panel

KHACHIMO

KHACHIMO TDR-960-24 24V 40A power supply

SKU CH-D8XH-XCBXE

Delivers 24V at 40A for 960W in an ATX form factor, tested working

  • TypeATX
  • Delivers 960 W continuous power for demanding 24 V systems
  • Provides 40 A output current to drive high-load equipment reliably
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good quality components

KHACHIMO TDR-960-24 24V 40A unit

This KHACHIMO power supply delivers 24 V at up to 40 A for industrial or test-bench use. It is built as an ATX-type switch-mode unit and has been test-verified for reliable operation. Buyers needing a different output voltage or a redundant hot-swap design should look elsewhere.

960 W capacity and headroom

The 960 W rating gives comfortable headroom for loads drawing up to the full 40 A at 24 V. Continuous operation at the maximum current is supported, but sustained loads beyond that rating will trigger protection or shutdown. Systems requiring higher peak power or multiple isolated rails are not suited to this single-output model.

Priekšrocības

  • Delivers 960 W continuous power for demanding 24 V systems
  • Provides 40 A output current to drive high-load equipment reliably
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good quality components

Specifikācijas

TypeATX

Jautājumi par šo preci

Will the KHACHIMO TDR-960-24 fit in my existing ATX case?

Yes, the unit follows the ATX form factor so it mounts in standard ATX chassis and uses the same screw pattern as older ATX supplies.

How can I verify the 24V 40A output is stable after installation?

Measure the DC output with a multimeter under load; it should read close to 24 V and deliver up to 40 A without shutting down.

Arī šajā sadaļā

Klienti arī salīdzināja

Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.