Priimame kriptovaliutą — taip monetos, kurias turite, gali nupirkti tikrą techniką.Mokėkite kriptovaliuta, išleiskite ją tikrai technikai. Nemokamas apdraustas pristatymas visame pasaulyje virš 399 $. Paprastos, be žymų siuntos dėžės, siunčiamos iš Vokietijos.Nemokamas apdraustas pristatymas virš 399 $. Jūsų kursas fiksuojamas 30 minučių, kai tik prasideda atsiskaitymas.Kursas fiksuojamas 30 minučių. Kiekvienas gaminys užplombuotas, jo serijos numeris patikrintas, ir jam taikoma 24 mėnesių garantija.Užplombuota, 24 mėnesių garantija.

Stebimos prekės Prisijungti

KHACHIMO

KHACHIMO TDR-960-24 24V 40A power supply

SKU CH-D8XH-XCBXE

Delivers 24V at 40A for 960W in an ATX form factor, tested working

  • TypeATX
  • Delivers 960 W continuous power for demanding 24 V systems
  • Provides 40 A output current to drive high-load equipment reliably
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good quality components

KHACHIMO TDR-960-24 24V 40A unit

This KHACHIMO power supply delivers 24 V at up to 40 A for industrial or test-bench use. It is built as an ATX-type switch-mode unit and has been test-verified for reliable operation. Buyers needing a different output voltage or a redundant hot-swap design should look elsewhere.

960 W capacity and headroom

The 960 W rating gives comfortable headroom for loads drawing up to the full 40 A at 24 V. Continuous operation at the maximum current is supported, but sustained loads beyond that rating will trigger protection or shutdown. Systems requiring higher peak power or multiple isolated rails are not suited to this single-output model.

Privalumai

  • Delivers 960 W continuous power for demanding 24 V systems
  • Provides 40 A output current to drive high-load equipment reliably
  • ATX form factor fits standard chassis mounting points
  • Tested working and built with good quality components

Specifikacijos

TypeATX

Klausimai apie šią prekę

Will the KHACHIMO TDR-960-24 fit in my existing ATX case?

Yes, the unit follows the ATX form factor so it mounts in standard ATX chassis and uses the same screw pattern as older ATX supplies.

How can I verify the 24V 40A output is stable after installation?

Measure the DC output with a multimeter under load; it should read close to 24 V and deliver up to 40 A without shutting down.

Taip pat šiame skyriuje

Kiti pirkėjai taip pat lygino

Ta pati lentyna, tas pats atsiskaitymas — aštuonios monetos ir 30 minučių fiksuotas kursas.