A-Tech 8GB DDR3L 1333 ECC UDIMM 2Rx8 1.35V 240-Pin
- 8GB
- DDR3L 1333 (PC3L 10…
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
A-Tech
An 8 GB DDR4 2400 MHz registered ECC DIMM with dual-rank x8 organisation for servers and workstations
Capacity 8GB
This A-Tech 8GB DDR4 2400 RDIMM is built for servers and workstations that require registered ECC memory. It operates at 2400 MHz with a CAS latency of 17 and runs at the standard 1.2V DDR4 voltage. The dual-rank 2Rx8 organisation uses major-brand chips on a 288-pin DIMM.
Registered buffering reduces electrical load on the memory controller, allowing sustained data rates during long compute or virtualisation tasks. ECC corrects single-bit errors on the fly, preventing silent data corruption that can accumulate over hours of operation. The module maintains its rated speed without throttling when installed in compatible multi-channel configurations.
At 1.2V the module draws minimal power, contributing little heat inside dense chassis where airflow is limited. Passive cooling via system fans is sufficient; no additional heatsinks or active cooling are required. The registered design also dampens signal noise on the bus, improving stability in fully populated memory channels.
| Brand | A-Tech |
|---|---|
| Series | A-Tech DDR4 Server Memory RAM |
| Model | A-Tech 8GB 2Rx8 PC4-2400T-R |
| Capacity | 8GB |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
The module operates at the standard DDR4 voltage of 1.20V. Actual power draw depends on the server platform and workload; the module itself has no separate power rating.
Your server or workstation must support DDR4 registered ECC memory in a 288-pin DIMM slot. Desktop and laptop platforms cannot use this module.
Mixing modules of different speeds or ranks is not recommended. The system will typically run all memory at the lowest common speed and may require specific population rules.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?