OWC 16GB DDR4 3200MHz CL22 1.2V 260pin SODIMM Alienware X17 R1
- 16GB
- 260-Pin DDR4 Non-EC…
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
A-Tech
8GB DDR4 desktop memory running at 3200MHz with CL22 latency and 1.2V operation
This A-Tech module delivers 8 GB of DDR4 memory at 3200 MHz with CL22 latency and 1.20 V operation. It uses a 288-pin unbuffered DIMM form factor built with major-brand chips. The stick is validated as a direct replacement for Kingston KVR32N22S6/8 and KCP432NS6/8 parts.
Builders upgrading a mainstream desktop that accepts non-ECC UDIMM memory can use this module. Systems that require ECC, registered DIMMs, or a different voltage should select a different part. The single-rank 1Rx16 organisation works with most consumer AMD and Intel platforms that support DDR4 3200.
The tested speed of 3200 MHz (PC4-25600) with CAS latency 22 at the standard 1.20 V determines whether this module matches the motherboard's supported profile. If the board only runs lower frequencies or tighter timings, the memory will down-clock accordingly.
| Brand | A-Tech |
|---|---|
| Capacity | 8GB |
| Speed | DDR4 3200 (PC4 25600) |
| Tested Frequency | 3200 |
| CAS Latency | CL22 |
| Voltage | 1.20V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major Brand Chips |
| Features | Major Brand Chipset |
| Recommend Use | AMD & Intel Compatible |
Yes, the stick is a JEDEC-standard DDR4 3200 module rated at CL22 1.20 V, so it will not exceed the 3200 MT/s data rate unless the motherboard manually raises frequency or tightens timings.
The module uses the regular 288-pin UDIMM form factor and a low-profile green PCB, so it fits any desktop DDR4 slot that is not blocked by an oversized CPU cooler.
Align the off-centre notch on the gold edge with the key in the slot, press straight down until both retention clips click, and verify the clips fully lock — partial seating is the most common cause of a no-post boot.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?