Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Flat orange flex cable one meter long sixteen millimetres wide point two millimetres thick

Adafruit

Adafruit Flex Cable for Raspberry Pi Camera 1 meter engineering development tool

SKU CH-SXSE-KKP8N

A 1 meter replacement flex cable for Raspberry Pi Camera boards, extending the stock 150mm length

  • TypeEngineering Development Tools
  • Reach camera positions up to 1 meter away with this extended flex cable
  • Replace the standard 150mm ribbon for flexible Pi Camera mounting
  • Slim 16mm wide by 0.2mm thick profile fits tight enclosures easily
  • Lightweight 7.5g cable adds minimal mass to moving or airborne projects
  • Raspberry Pi and Camera Board not included — cable only purchase

Extension cable for Raspberry Pi cameras

This one-metre flex cable replaces the stock 150 mm ribbon on classic or NoIR Raspberry Pi camera boards. It measures 1 metre by 16 mm by 0.2 mm and weighs 7.5 g. The Raspberry Pi and camera board are not included in the package.

Installing the replacement ribbon

Open the connector on the Pi carefully and slide the new cable in; the process is straightforward but requires gentle handling to avoid damaging the contacts. At 3.3 ft the longer run can pick up noise in electrically harsh environments, which may result in corrupted images.

Signal integrity limits of the CSI interface

The CSI protocol used by the camera is not designed for one-metre lengths, so image quality can degrade in noisy surroundings. Users who need reliable capture over longer distances should consider alternative connection methods rather than extending the flex cable further.

Kohokohdat

  • Reach camera positions up to 1 meter away with this extended flex cable
  • Replace the standard 150mm ribbon for flexible Pi Camera mounting
  • Slim 16mm wide by 0.2mm thick profile fits tight enclosures easily
  • Lightweight 7.5g cable adds minimal mass to moving or airborne projects
  • Raspberry Pi and Camera Board not included — cable only purchase

Tekniset tiedot

TypeEngineering Development Tools

Kysymyksiä tästä tuotteesta

How can I verify the 1 meter flex cable is seated correctly after installation?

After sliding the cable into the Pi's connector, check that the camera initialises without errors and captures stable images; if frames appear corrupted in a noisy environment, try a shorter cable.

What does the package contain and what must I source separately?

The box holds one 1 meter flex cable measuring 16 mm wide and 0.2 mm thick; you must supply your own Raspberry Pi board and Camera module.

Which length should I choose for a standard Pi Camera setup?

The 1 meter cable replaces the stock 150 mm flex and works with classic or NoIR cameras on Model B or B+, but 3.3 ft may introduce corruption in electrically noisy settings.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.