NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
ASUS
A GeForce RTX 2080 with 8 GB GDDR6 memory, 2944 CUDA cores, a 1740 MHz boost clock and a 260 W TDP in a blower-style cooler for multi-GPU builds
This graphics card uses the NVIDIA RTX architecture with 2944 CUDA cores and 8GB GDDR6 memory on a 256-bit bus. It is built for users who need reliable compute performance in multi-GPU systems or cases with restricted airflow. The Turbo design focuses on exhausting heat directly out of the chassis rear. A 260W TDP requires a suitably rated power supply.
The card installs into a standard PCIe 3.0 x16 slot and occupies two expansion brackets at the rear. Its blower-style cooler exhausts hot air out the back, which helps in tight builds but demands good case ventilation to prevent heat buildup. Ensure the power connectors are fully seated and that no cables obstruct the intake side of the shroud. Driver installation follows the standard NVIDIA package for the RTX 2080.
Under continuous load the GPU maintains its 1740 MHz boost clock within the 260W thermal limit. The radial fan spins faster to move air through the heatsink and out the rear vent, which raises acoustic output compared to open-air coolers. Memory runs at 14 Gbps across the 256-bit interface without throttling in typical gaming or compute workloads. Temperatures stabilise higher than open-air designs but remain within specification.
| Thermal Design Power | 260W |
|---|
Use GPU monitoring software such as GPU-Z or MSI Afterburner to observe the core frequency under a 3D load; the sensor should report speeds approaching 1740 MHz when the card is operating within its 260 W power limit and thermal targets.
The card ships only with the graphics board itself; you must supply two 8-pin PCIe power connectors from your power supply to meet the 260 W TDP requirement.
Compare the factory boost clock — this Turbo EVO model reaches 1740 MHz versus the 1710 MHz reference — along with the blower-style cooler designed for multi-GPU or restricted-airflow chassis.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?