Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Clear PETG tube 12mm outer diameter 1000mm length

Bitspower

Bitspower BP-NCPLT12-L1000 PETG tubing 12mm OD 1000mm clear

SKU CH-36PP-JYKX9 MPN BP-NCPLT12-L1000

Clear PETG tubing with 12mm outer diameter and 1000mm length, designed for Bitspower EML fittings

  • TypeTubing
  • PETG link tubing resists cracking with durable material strength
  • 12 mm outer diameter fits Bitspower EML series fittings
  • 1000 mm length gives full loop routing flexibility
  • Clear PETG shows coolant colour without distortion
  • Designed specifically for Bitspower EML fittings only

Crystal Link Tubing 12 mm

Bitspower Crystal Link Tubing is rigid PETG pipe with a 12 mm outer diameter and a 1000 mm length. The clear material shows coolant colour and flow. It is made for custom liquid-cooling loops that use hard-line tubing. Builders who want a transparent, structural run choose this tube.

Replaces soft tubing runs

Soft tubing can kink, cloud or plasticise over time; this PETG link tube removes those failure points. The jump is worth it when a build demands fixed geometry, long straight spans or a cleaner aesthetic. It is not for loops that need tight bends without angled fittings.

One metre straight length

A single 1000 mm piece covers most motherboard-tray-to-radiator or reservoir-to-pump runs in mid-tower cases. Two pieces handle a CPU-plus-GPU loop with a top radiator. Builds with multiple radiators or external distribution plates will need additional lengths.

Kohokohdat

  • PETG link tubing resists cracking with durable material strength
  • 12 mm outer diameter fits Bitspower EML series fittings
  • 1000 mm length gives full loop routing flexibility
  • Clear PETG shows coolant colour without distortion
  • Designed specifically for Bitspower EML fittings only

Tekniset tiedot

TypeTubing

Kysymyksiä tästä tuotteesta

Which fittings are required for the 12 mm OD PETG tubing?

Use Bitspower EML series fittings; the tubing is designed for that specific fitting line only.

What is the correct way to cut and seat the 1000 mm PETG tube?

Cut square with a fine-tooth saw, deburr the edge, then push fully into the EML fitting until the tube bottoms out against the internal stop.

When should the clear PETG tube be replaced in a custom loop?

Replace if the tube turns yellow, clouds, stiffens or shows micro-cracks — typically after one to two years depending on coolant and temperature.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.