EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
Computer Memory Solutions
Registered DDR2 400 ECC kit with two 2 GB modules for Dell PowerEdge SC1425 servers
This 4 GB kit contains two 2 GB registered ECC DIMMs built for the Dell PowerEdge SC1425 server. Each module uses a 240-pin DDR2 interface running at 400 MHz with CL3 timing. The dual-rank design matches the platform requirement that additional memory be installed in pairs.
Registered buffering reduces electrical load on the memory controller during continuous server workloads. ECC circuitry detects and corrects single-bit errors without halting the system. Dual-rank organisation allows the chipset to interleave accesses across ranks for steadier throughput under prolonged demand.
Modules operate at the standard 1.8 V for DDR2 with no heat spreaders attached. Passive cooling relies on chassis airflow, so noise contribution is limited to the server fans already present. Power draw scales with the two populated slots and stays within the platform’s designed envelope.
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM256723200ECCREG2R4 |
| Capacity | 4GB (2 x 2GB) |
| Type | 240-Pin DDR2 SDRAM |
| Speed | DDR2 400 (PC2 3200) |
| CAS Latency | CL3 |
| Timing | 3-3-3 |
| Voltage | 1.8V |
| ECC | No |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Dell Poweredge Sc1425 (1425Sc |
| Package Content | 2 Memory RAM Sticks |
The modules operate at 1.8 volts and use registered signalling to reduce electrical load on the memory controller, keeping heat output low enough for standard server airflow in the SC1425 chassis.
The system needs a motherboard that accepts 240-pin DDR2 registered ECC memory and a BIOS that supports dual-rank 2Rx4 modules; the first slot can be filled singly, but any further memory must be added in matched pairs.
Yes — all modules must run at the same 400 MHz speed and CL3 timing, so the memory controller will down-clock everything to the slowest common setting, preserving stability within the eight-rank limit of the chipset.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?