Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Clear 1.75mm filament spool, 750g, glossy transparent finish

E3D Online

E3D Online spoolWorks EDGE Filament 1.75mm 750g Clear Crystal01

SKU CH-M125-5EPJB

A tough, recyclable PETG-based filament that prints with low warp, minimal odour and strong layer adhesion

  • TypeFilament
  • Recyclable PETG-based material reduces environmental impact
  • Prints without unpleasant fumes or odours for a better workspace
  • Strong, tough and naturally glossy finish produces durable, shiny parts
  • Adheres to bed surfaces with only a little gluestick for easier first layers
  • Works with Scaffold support material for reliable adhesion and clean breakaway

Edge filament for reliable everyday printing

This 1.75mm PETG-based Edge filament comes on a 750g spool and is aimed at makers who want strong, accurate parts without the warping or fumes often associated with ABS. It suits hobbyists and small workshops printing functional prototypes, jigs or end-use models that must hold together under load.

Low contraction keeps dimensions steady over long

Edge is engineered with super-low contraction so large or tall builds stay true to size layer after layer. Managed viscosity and melt strength let you run demanding overhangs and tight bridges without constant babysitting, while molecular-level layer adhesion means Z-strength approaches XY-strength even on extended jobs.

Odour-free printing with modest bed prep

The material prints with no unpleasant fumes or odours, making it practical for shared or home spaces. A light gluestick coating is enough for solid first-layer grip, and pairing with Scaffold support material gives clean breakaway on complex geometry. Recyclable PETG base reduces waste when spools are finished.

Kohokohdat

  • Recyclable PETG-based material reduces environmental impact
  • Prints without unpleasant fumes or odours for a better workspace
  • Strong, tough and naturally glossy finish produces durable, shiny parts
  • Adheres to bed surfaces with only a little gluestick for easier first layers
  • Works with Scaffold support material for reliable adhesion and clean breakaway

Tekniset tiedot

ModelEdge
TypeFilament

Kysymyksiä tästä tuotteesta

Does the filament give off any fumes or odours when the printer runs continuously?

The supplier states it prints with no unpleasant fumes or odours, making it suitable for long sessions in shared spaces.

What printer specification must I already have to use this 1.75mm spool?

Your 3D printer must accept 1.75mm diameter filament; the spool weighs 750g and fits standard holders.

Will this PETG-based material bond reliably to the older heated bed on my current machine?

It adheres effectively to common bed surfaces with just a little gluestick, so older heated beds work well.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.