Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Rectangular black ATX power supply with modular cable sockets and a 135 mm fan grille

FSP

FSP 1350 power supply 1350W ATX 3.1 PCIe 5.1 80 Plus Platinum

SKU CH-R72H-17PT7 MPN 1350

ATX 3.1 compliant 1350 W unit with dual PCIe 5.1 connectors and 80 Plus Platinum efficiency

  • TypeATX 3.0 Compatible
  • Maximum Power1350 W
  • PFCActive
  • Main Connector24Pin
  • +12V Rails2
  • PCI-Express Connector1 x 6+2-Pin
  • Delivers 1350 W for high-end multi-GPU builds
  • 80 Plus Platinum rating reaches 92 % efficiency at typical load
  • ATX 3.1 and PCIe 5.1 (12V-2X6) connectors support latest graphics cards
  • Eco semi-fanless switch stops the 135 mm FDB fan at low load
  • Fully modular ribbon cables simplify routing and keep the interior tidy

High-wattage ATX 3.1 supply for demanding builds

This 1350 W unit meets ATX 3.1 and PCIe 5.1 requirements, delivering up to 1350 watts through a single +12 V rail. It targets enthusiasts and workstation builders who need headroom for multi-GPU configurations or sustained heavy compute loads. The fully modular design uses flat ribbon cables to simplify routing in tight chassis.

Semi-fanless operation and 92 % typical efficiency

An eco switch enables semi-fanless mode, so the 135 mm FDB fan stays off until internal temperatures demand active cooling. At typical loads the unit exceeds 92 % efficiency, reducing waste heat and keeping power draw from the wall lower. Active PFC handles 110 – 240 V input automatically for worldwide use.

Ribbon cables, DC-to-DC modules

Flat ribbon cables improve cable management and airflow compared with traditional sleeved wires. Separate +3.3 V and +5 V DC-to-DC modules provide tighter voltage regulation for modern platforms. Magnetic side stickers can be swapped to match a build theme without tools. Full protection suite covers over-current, over-voltage, over-power, short-circuit, over-temperature and under-voltage events.

Kohokohdat

  • Delivers 1350 W for high-end multi-GPU builds
  • 80 Plus Platinum rating reaches 92 % efficiency at typical load
  • ATX 3.1 and PCIe 5.1 (12V-2X6) connectors support latest graphics cards
  • Eco semi-fanless switch stops the 135 mm FDB fan at low load
  • Fully modular ribbon cables simplify routing and keep the interior tidy

Tekniset tiedot

BrandFSP Group
Series80 Plus
Model1350
TypeATX 3.0 Compatible
Maximum Power1350 W
PFCActive
Main Connector24Pin
+12V Rails2
PCI-Express Connector1 x 6+2-Pin
ModularYes
Efficiency> 79%
Energy-Efficient80 PLUS Certified
Connectors1 x 24 pin ATX
Weight10
Input Voltage110 - 120 V/ 220 - 240 V

Kysymyksiä tästä tuotteesta

Will this unit fit a standard ATX case and deliver the full 1350 W on a 240 V mains supply?

Yes, it follows the ATX form factor and the input range covers 220 – 240 V, so full rated power is available on UK mains.

Does the modular cable set include two native 12V-2X6 connectors for modern PCIe 5.1 graphics cards?

The specification lists two PCIe 5.1 (12V-2X6) connectors, so current-generation GPUs can be powered without adapters.

How quiet is the 135 mm FDB fan under light loads?

An eco semi-fanless switch stops the fan completely until internal temperatures rise, giving silent operation at idle and low load.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.