NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
GIGABYTE
ATX board for 10th and 11th Gen Intel CPUs with three M.2 slots, six SATA III ports, PCIe 4.0, USB 3.2 Gen2 Type-A and Type-C, and 128 GB DDR4 capacity
This motherboard uses the Intel Z590 chipset and an LGA 1200 socket to support 10th and 11th generation Core, Pentium and Celeron processors. It provides four DDR4 DIMM slots for up to 128 GB of dual-channel memory at speeds from 2133 to 3200 MHz. The ATX form factor measures 30.5 by 24.4 cm and fits standard cases.
The board follows the standard ATX mounting pattern and uses a 24-pin plus 12-pin power arrangement. Install the CPU, secure the cooler, populate the DIMM slots and connect the front-panel headers. The three M.2 slots each need a small standoff screw; dropping or misplacing these screws is the most common issue. Route the six SATA III cables and front-panel USB leads before the graphics card goes in to avoid tight clearances.
An 18+1 phase power design feeds the CPU socket, keeping voltage stable during extended all-core boosts from 10th and 11th generation chips. The chipset and VRM heatsinks dissipate heat without active fans, so sustained compile, render or encoding runs stay within thermal limits. PCIe 4.0 on the primary x16 slot and M.2 interfaces maintains full throughput to graphics cards and SSDs throughout long sessions.
Tälle tuotteelle ei ole vielä julkaistu teknisiä tietoja.
Enter the BIOS and verify the PCIe slot shows Gen 4.0 link width x16 for the primary slot; under Windows, GPU-Z or HWInfo will report the active link speed as 4.0 when a compatible graphics card is seated.
The retail package contains the ATX motherboard, I/O shield, SATA cables, M.2 mounting screws and documentation; you must supply an LGA 1200 CPU, DDR4 memory modules, storage drives, power supply and CPU cooler.
The board officially supports dual-channel DDR4 at 2133, 2400, 2666, 3000 and 3200 MHz; 3200 MHz kits give the highest rated frequency while remaining within the validated range.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?