Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
A silver ATX power supply with single fan and multiple cables

Gulfe

Gulfe ATX Power Supply for HP Pavilion Elite M9400Z M9402F

SKU CH-18SG-SFXJ7

ATX power supply with reduced depth, 115/230 V input, and 24-pin, 4-pin, SATA, LP4 and floppy connectors

  • TypeATX
  • Fans1
  • Weight2.5
  • Replaces legacy HP Elite M9400Z M9402F units
  • Reduced depth 5.9" height fits tight ATX cases
  • Dual 12 V rails with over-current protection
  • 24-pin ATX, 4-pin CPU, three SATA connectors
  • High-efficiency design tested for low ripple noise

Gulfe ATX PSU for HP Pavilion Elite M9400Z M9402F

This new Gulfe ATX power supply replaces legacy units in HP Pavilion Elite M9400Z and M9402F media centre desktops. It delivers standard output rails including +5V, -5V, +12V1, +12V2, +3.3V, -12V and +5V standby. Over-current and over-power protection circuits guard connected components. Reduced depth improves fit inside the original chassis.

Fits HP Pavilion Elite M9400Z and M9402F only

Builders restoring these specific HP models can use this unit as a direct swap. Systems requiring different connector layouts, higher total wattage or proprietary form factors should look at other options. The single fan provides basic cooling for the original hardware configuration. This unit does not support modern high-power graphics cards or newer motherboard power standards.

Connector set decides compatibility

The harness includes one 24-pin ATX connector, one 4-pin P4 12V connector, three SATA 15-pin connectors, two LP4 4-pin connectors and one floppy 4-pin connector. Missing PCIe power plugs rule out discrete graphics upgrades. Verify your motherboard and drive requirements against this exact list before purchase.

Kohokohdat

  • Replaces legacy HP Elite M9400Z M9402F units
  • Reduced depth 5.9" height fits tight ATX cases
  • Dual 12 V rails with over-current protection
  • 24-pin ATX, 4-pin CPU, three SATA connectors
  • High-efficiency design tested for low ripple noise

Tekniset tiedot

BrandGulfe
TypeATX
Fans1
Weight2.5

Kysymyksiä tästä tuotteesta

How long will the power supply maintain output after mains voltage drops?

The unit provides a minimum hold-up time of 17 ms at nominal input, keeping rails alive during brief interruptions.

What noise level and thermal load should I expect when the PSU runs continuously?

A single internal fan cools the unit; the supplier notes low ripple and noise but does not publish a decibel rating or thermal output figure.

Which existing cables or motherboard headers must my system already have for this PSU to connect?

Your motherboard needs a 24-pin ATX socket and a 4-pin P4 12 V header; drives require SATA power ports or LP4 connectors.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.