Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

LORDWORLD

LORDWORLD ESP32-C6 Development Board ESP32-C6-WROOM-1-N8 8MB Flash

SKU CH-YPBD-MFYF3

IoT development board with RISC-V 32-bit processor at 160MHz, 8MB flash, WiFi 6, Bluetooth 5 and IEEE 802.15.4, USB-UART via CH343 and CH334, castellated module for carrier boards

  • RISC-V 32-bit single-core processor up to 160MHz for efficient edge computing
  • 8MB Flash built into ESP32-C6-WROOM-1-N8 module stores firmware and data
  • WiFi 6 plus Bluetooth 5 and IEEE 802.15.4 for multi-protocol IoT connectivity
  • USB Type-C with CH343 and CH334 chips enables USB and UART development
  • Pin-compatible with ESP32-C6-DevKitC-1-N8 and castellated for carrier-board soldering

ESP32-C6 RISC-V development board

This LORDWORLD board integrates the ESP32-C6-WROOM-1-N8 module with a 32-bit single-core RISC-V processor running up to 160MHz and 8MB flash storage. It targets makers and engineers building IoT edge devices that need WiFi 6, Bluetooth 5, and IEEE 802.15.4 connectivity in a compact form factor. The castellated module design also allows direct soldering onto custom carrier boards for production deployments.

Low-power wireless operation

The ESP32-C6 chip is designed for energy-efficient IoT applications with its RISC-V core and integrated radio subsystems. WiFi 6, Bluetooth 5, and IEEE 802.15.4 (supporting Zigbee 3.0 and Thread) share the same silicon, enabling multi-protocol connectivity without additional power-hungry components. The onboard CH343 and CH334 chips handle USB-to-UART conversion through the Type-C connector for development and debugging.

Pin-compatible expandability

The board matches the ESP32-C6-DevKitC-1-N8 pinout, letting you reuse existing shield designs and peripheral layouts. Onboard CH343 and CH334 chips provide USB and UART interfaces over a single Type-C port, simplifying firmware flashing and serial monitoring. Castellated edges on the module enable direct surface-mount assembly onto custom PCBs when moving from prototype to production.

Kohokohdat

  • RISC-V 32-bit single-core processor up to 160MHz for efficient edge computing
  • 8MB Flash built into ESP32-C6-WROOM-1-N8 module stores firmware and data
  • WiFi 6 plus Bluetooth 5 and IEEE 802.15.4 for multi-protocol IoT connectivity
  • USB Type-C with CH343 and CH334 chips enables USB and UART development
  • Pin-compatible with ESP32-C6-DevKitC-1-N8 and castellated for carrier-board soldering

Tekniset tiedot

BrandLORDWORLD

Kysymyksiä tästä tuotteesta

How do I install the board and what step do people often miss?

Connect the Type-C cable to install drivers for the onboard CH343 and CH334 chips, then select the correct COM port in your IDE; the step often missed is putting the ESP32-C6-WROOM-1-N8 module into boot mode by holding the BOOT button while pressing RESET before uploading code.

What maintenance or replacement will this development board need later?

The board has no user-replaceable parts; long-term care is limited to keeping the Type-C connector and castellated module pads free of dust and corrosion, and re-flashing the 8MB Flash if firmware becomes corrupted.

What limit appears first when the board runs continuously at 160MHz with WiFi 6 and Bluetooth 5 active?

The on-module RF front-end and voltage regulator reach thermal saturation first, causing the ESP32-C6-WROOM-1-N8 to throttle its RISC-V 32-bit single-core processor below 160MHz to protect the 8MB Flash and wireless circuitry.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.