NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
Micro Connectors
A 5V 2.5A Micro USB power adapter with a built-in on/off switch, UL and FCC approved, DoE Level VI efficiency, and over-voltage and short-circuit protection for Raspberry Pi boards
This Micro Connectors 5V 2.5A Micro USB power adapter delivers a stable 12.5W output for Raspberry Pi boards and similar development devices. The integrated on/off switch lets you cycle power without unplugging the cable, reducing connector wear during frequent restarts. UL and FCC approvals plus over-voltage and short-circuit protection provide safe operation across 100-240V AC mains.
The adapter meets DoE Level VI efficiency standards, limiting no-load and active-mode waste heat during continuous use. A 47-inch cable allows flexible placement away from the power strip, keeping the brick clear of other equipment. With a weight of 0.25 lb the unit adds negligible load to a bench or enclosure mount.
Makers who have relied on generic phone chargers gain a dedicated 2.5A supply rated for the full load of a Raspberry Pi 3, Pi 2, Pi 1 or Pi Zero. The inline switch eliminates the need to pull the Micro USB plug for every reboot, preserving the board's power port. Builders needing higher current for Pi 4 or USB-C devices should select a different adapter.
| Brand | Micro Connectors |
|---|---|
| Model | RAS-PWR03-PI |
| Features | Specifications: Input: AC 100-240V / 50-60 Hz Output: DC 5V / 2.5A Cable length: 47 inches (3.9 feet) Weight: 0.25 lb. Features: UL and FCC Approved Convenient ON/OFF Switch DoE Level VI Efficiency Over Circuit Protection Short Circuit Protection Compatible with all Raspberry Pi Micro-USB connector |
| Lähetyspaino | 0.09 kg |
| Pakkauksen mitat | 157 × 64 × 38 mm |
Plug the Micro USB connector into the Pi's power input, then use the inline on/off switch to control power instead of repeatedly unplugging the cable. The 47 inch cable provides enough length to position the adapter conveniently.
The built-in on/off switch is designed to handle daily power cycling so the Micro USB connector does not take mechanical stress. The 3.9 foot cable is fixed to the adapter and not user-replaceable.
The adapter delivers up to 2.5A at 5V (12.5W) continuously. Over voltage and short-circuit protection will activate if the connected draw exceeds the rated output or a fault occurs.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?