NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.
Micro Connectors
A 5V 2.5A Micro USB power adapter with a built-in on/off switch, UL and FCC approved, DoE Level VI efficiency, and over-voltage and short-circuit protection for Raspberry Pi boards
This Micro Connectors 5V 2.5A Micro USB power adapter delivers a stable 12.5W output for Raspberry Pi boards and similar development devices. The integrated on/off switch lets you cycle power without unplugging the cable, reducing connector wear during frequent restarts. UL and FCC approvals plus over-voltage and short-circuit protection provide safe operation across 100-240V AC mains.
The adapter meets DoE Level VI efficiency standards, limiting no-load and active-mode waste heat during continuous use. A 47-inch cable allows flexible placement away from the power strip, keeping the brick clear of other equipment. With a weight of 0.25 lb the unit adds negligible load to a bench or enclosure mount.
Makers who have relied on generic phone chargers gain a dedicated 2.5A supply rated for the full load of a Raspberry Pi 3, Pi 2, Pi 1 or Pi Zero. The inline switch eliminates the need to pull the Micro USB plug for every reboot, preserving the board's power port. Builders needing higher current for Pi 4 or USB-C devices should select a different adapter.
| Brand | Micro Connectors |
|---|---|
| Model | RAS-PWR03-PI |
| Features | Specifications: Input: AC 100-240V / 50-60 Hz Output: DC 5V / 2.5A Cable length: 47 inches (3.9 feet) Weight: 0.25 lb. Features: UL and FCC Approved Convenient ON/OFF Switch DoE Level VI Efficiency Over Circuit Protection Short Circuit Protection Compatible with all Raspberry Pi Micro-USB connector |
| Prepravná hmotnosť | 0.09 kg |
| Rozmery balenia | 157 × 64 × 38 mm |
Plug the Micro USB connector into the Pi's power input, then use the inline on/off switch to control power instead of repeatedly unplugging the cable. The 47 inch cable provides enough length to position the adapter conveniently.
The built-in on/off switch is designed to handle daily power cycling so the Micro USB connector does not take mechanical stress. The 3.9 foot cable is fixed to the adapter and not user-replaceable.
The adapter delivers up to 2.5A at 5V (12.5W) continuously. Over voltage and short-circuit protection will activate if the connected draw exceeds the rated output or a fault occurs.
Aj v tomto oddelení
Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.
Mena, v ktorej platíte, a mena, v ktorej sa zobrazujú ceny.
Odoslané z vašej peňaženky na pokladni
Len na zobrazenie — katalóg je uvedený v dolároch
Žiadna mena nezodpovedá.
Vyberte jazyk, v ktorom s vami bude web komunikovať.
Ste tu prvýkrát?
Účet už máte?
Automatický reset hesla neexistuje: tento obchod neposiela žiadne e-maily, takže neexistuje jednorazový odkaz, o ktorý by ste mohli požiadať. Nechajte adresu na účte — niekto sa jej ujme ručne.
Žiadosť zaznamenaná
Do vašej schránky nič nepríde — tento obchod neposiela vôbec žiadne e-maily. Niekto sa o to postará ručne.
Spomenuli ste si?