Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
A black ATX power supply with a red 14cm fan visible through the grille

myVolts

myVolts ATX-600W 600W power supply red fan 14cm 115/230V

SKU CH-4MYA-PERMB MPN ATX-600W

A 600 W ATX power supply with a 14 cm fan, 80 % efficiency, 20+4 pin motherboard connector, six SATA ports, dual 6+2 pin GPU leads and manual 115/230 V switching

  • TypeAT
  • Clear connector labels speed up installation
  • 14 cm fan with thermal sensor adjusts speed for quiet operation
  • Manual 115/230 V switch suits global mains
  • 600 W output with >80 % efficiency powers basic desktops
  • Double magnetic ring design follows Intel ATX12V 2.31 spec

600 W ATX power supply for basic desktops

This unit delivers 600 W of rated power in a standard ATX form factor. It targets builders assembling low-energy, low-noise office or home PCs. Clearly marked connectors simplify cable routing during assembly. The manual 115/230 V switch lets the supply operate worldwide without extra hardware.

Thermal sensor fan control and double magnetic ring

A 14 cm fan spins under automatic thermal control, so speed rises only when internal temperature demands it. The double magnetic ring design follows the Intel ATX12V 2.31 specification for stable output. Efficiency exceeds 80 percent, keeping waste heat and acoustic output low in typical desktop workloads. Hold-up time is rated above 10 ms for brief mains interruptions.

Connectors for motherboard CPU drives and graphics

The supply provides a 20+4 pin motherboard connector, a 4+4 pin CPU connector, six SATA connectors and two 6+2 pin PCIe connectors. Three fan headers are available for case cooling. Dimensions are approximately 150 x 160 x 86 mm with a 1.1 metre mains lead. Builds needing more than six SATA devices or additional PCIe power cables will require a different unit.

Kohokohdat

  • Clear connector labels speed up installation
  • 14 cm fan with thermal sensor adjusts speed for quiet operation
  • Manual 115/230 V switch suits global mains
  • 600 W output with >80 % efficiency powers basic desktops
  • Double magnetic ring design follows Intel ATX12V 2.31 spec

Tekniset tiedot

TypeAT

Kysymyksiä tästä tuotteesta

How do I connect the 20+4 pin motherboard connector and the 4+4 pin CPU cable, and which step do builders often miss?

Match the keyed 20+4 pin plug to the motherboard socket and the 4+4 pin plug to the CPU 12 V header; the step most often missed is flipping the manual 115/230 V switch to match the local mains before first power-on.

What component will likely need replacement first, and after how many hours?

The 14 cm cooling fan is the only moving part; the unit is rated for 100000 hours of operation, so the fan is the component most likely to require replacement after extended use.

At what load does the thermal sensor ramp the fan to maximum speed under sustained operation?

The internal thermal sensor automatically increases fan speed as temperature rises; sustained loads approaching the 600 W rating will cause the fan to run at its highest speed to maintain cooling.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.