Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green bare circuit board DDR5 RDIMM module 288-pin edge connector 48GB capacity

NEMIX RAM

NEMIX RAM 48GB DDR5 4800 CL40 2Rx8 ECC RDIMM Supermicro H14DST-F memory upgrade

SKU CH-30X7-J2GD7

48GB DDR5 4800 ECC registered RDIMM with 2Rx8 rank, CL40 latency and 1.1V operation, validated for Supermicro H14DST-F motherboards

  • Capacity48GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 48GB

Näytä 30 muuta kokoonpanoa
  • Exact-match 48GB DDR5-4800 CL40 2Rx8 RDIMM for full-speed recognition
  • Registered ECC architecture offloads controller and corrects bit errors
  • Verified fit for Supermicro H14DST-F 288-pin RDIMM slots
  • Major OEM Samsung Micron Hynix chips ensure enterprise-grade stability
  • Lifetime replacement warranty with US-based technical support included

Exact-match upgrade for Supermicro H14DST-F

This 48GB DDR5 RDIMM runs at 4800 MT/s with CL40 timing and 1.1V operation. Registered ECC architecture with 2Rx8 organisation delivers the precise rank, voltage and latency the server memory controller expects for full-capacity recognition at rated speed.

Thermals noise and power draw

Operating at 1.10V without a heat spreader, the module relies on standard server airflow for cooling. Registered buffering reduces electrical load on the memory controller, helping maintain stable power draw across fully populated slots during continuous enterprise workloads.

Build fit and system requirements

The 288-pin RDIMM form factor matches the H14DST-F memory slots exactly; UDIMM or SODIMM modules will not fit. ECC and registered operation require a compatible server platform — desktop or consumer motherboards cannot use this memory. Verify your system manual for approved population order and maximum supported capacity per channel before installation.

Kohokohdat

  • Exact-match 48GB DDR5-4800 CL40 2Rx8 RDIMM for full-speed recognition
  • Registered ECC architecture offloads controller and corrects bit errors
  • Verified fit for Supermicro H14DST-F 288-pin RDIMM slots
  • Major OEM Samsung Micron Hynix chips ensure enterprise-grade stability
  • Lifetime replacement warranty with US-based technical support included

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-4828K1
Capacity48GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content48GB DDR5 4800MHz PC5-38400 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

How do I install the 48GB DDR5 4800 RDIMM in my Supermicro H14DST-F, and which step is commonly missed?

Power down, open the chassis, and insert the 288-pin module into the slot specified by the motherboard manual for your population order; the step often missed is confirming the exact DIMM sequence before seating the registered ECC stick.

What maintenance or replacement will the 2Rx8 ECC RDIMM need over its service life?

No scheduled maintenance is required; ECC corrects single-bit errors automatically, and the module is replaced only if uncorrectable errors appear or a capacity upgrade is needed.

What limit appears first when the 48GB DDR5 4800 CL40 kit runs sustained workloads?

The memory controller’s maximum supported capacity per channel or total populated slots, as defined in the H14DST-F manual, is reached before the module’s own 4800 MT/s rating or 1.1 V operation becomes a constraint.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.