Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Eight green DDR5 RDIMM modules in a row

NEMIX RAM

NEMIX RAM 512GB (8x64GB) DDR5 5600 CL46 1.1V ECC RDIMM Supermicro X14SRA-T memory upgrade

SKU CH-FZM7-8H8WB

512 GB DDR5 ECC RDIMM kit with eight 64 GB modules at 5600 MT/s, CL46, 1.1 V, registered for Supermicro X14SRA-T

  • Capacity512GB (8 x 64GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 512GB 8X64GB

Näytä 4 muuta kokoonpanoa
  • 512 GB capacity in an 8 × 64 GB kit for maximum Supermicro X14SRA-T memory density
  • DDR5 5600 (PC5-44800) speed with CL46 latency matches the board's rated timing exactly
  • Registered ECC RDIMM architecture offloads the memory controller and corrects single-bit errors on the fly
  • 1 V operating voltage and 2Rx4 rank configuration align with the motherboard's memory-controller requirements
  • 288-pin DDR5 RDIMM form factor is the precise module type the X14SRA-T slots accept

Exact-match DDR5 kit for Supermicro X14SRA-T

This 512 GB kit contains eight 64 GB DDR5 5600 RDIMMs built to the exact rank, voltage and timing the motherboard expects. Registered ECC architecture lets every slot run fully populated at rated speed while correcting single-bit errors on the fly. Modules are 288-pin 2Rx4 devices operating at 1.10 V with CL46 latency.

Sustained-load stability with registered ECC

Registered buffering offloads the memory controller so all eight modules maintain full throughput under continuous server workloads. ECC detection and correction runs constantly, preventing silent data corruption and unplanned reboots during long-running tasks. The 1.10 V operating voltage supports consistent operation across the full population.

Verify DIMM population rules before ordering

Server memory support varies by model and BIOS revision. Consult the Supermicro X14SRA-T manual for approved capacities, slot population order and installation steps. This kit requires 288-pin RDIMM slots and will not fit UDIMM or SODIMM sockets. Ensure your configuration matches the 2Rx4 registered specification.

Kohokohdat

  • 512 GB capacity in an 8 × 64 GB kit for maximum Supermicro X14SRA-T memory density
  • DDR5 5600 (PC5-44800) speed with CL46 latency matches the board's rated timing exactly
  • Registered ECC RDIMM architecture offloads the memory controller and corrects single-bit errors on the fly
  • 1 V operating voltage and 2Rx4 rank configuration align with the motherboard's memory-controller requirements
  • 288-pin DDR5 RDIMM form factor is the precise module type the X14SRA-T slots accept

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-924K8
Capacity512GB (8 x 64GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content512GB 8X64GB DDR5 5600MHz PC5-44800 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Does the 1.1 V registered ECC kit run hot or draw extra power when the server operates 24/7?

The modules operate at the standard DDR5 server voltage of 1.10 V with no heat spreader, so power draw and thermals stay within normal registered DIMM limits for continuous operation.

What motherboard slot type must my Supermicro X14SRA-T provide for these 288-pin RDIMMs?

The board needs DDR5 288-pin RDIMM slots; the kit is spec-matched to the X14SRA-T memory population rules and will not fit UDIMM or SODIMM sockets.

Can I mix these 64 GB 2Rx4 modules with smaller capacity registered DIMMs already installed?

Yes, provided the motherboard manual approves the mixed population order; the 2Rx4 rank structure and CL46 timing are the exact match the X14SRA-T memory controller expects.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.