Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

NEMIX RAM

NEMIX RAM 64GB (2x32GB) DDR5 5600 ECC UDIMM CL46 1.1V 2Rx8 memory upgrade

SKU CH-4GK5-616Q6

A 64 GB DDR5 ECC UDIMM kit running at 5600 MHz with CL46 latency and 1.1 V operation for the Supermicro X13SAW-F motherboard

  • Capacity64GB (2 x 32GB)
  • Type288-Pin DDR5 ECC UDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 64GB 2X32GB

  • ECC protection stops silent data corruption with on-the-fly single-bit error correction
  • 64 GB capacity delivered as two 32 GB modules for full dual-channel bandwidth
  • DDR5 5600 speed rated at PC5-44800 for high-throughput workloads
  • Low 1.10 V operation reduces power draw and thermal load
  • Verified fit for Supermicro X13SAW-F with 288-pin UDIMM form factor

Exact DDR5-5600 ECC kit for Supermicro X13SAW-F

This NEMIX RAM kit delivers 64 GB across two 32 GB unbuffered ECC UDIMMs rated at DDR5 5600 with CL46 timings at 1.10 V. The 2Rx8 modules match the board's required rank structure and voltage so the memory controller recognises full capacity at rated speed.

Verify motherboard manual for population rules

Confirm that your Supermicro X13SAW-F motherboard supports 64 GB total and the approved DIMM slot order for a two-module kit. The board requires 288-pin unbuffered ECC UDIMMs; RDIMM or SODIMM variants will not fit or function correctly.

Suits workstations needing ECC reliability on this

Builders who need a different form factor, registered DIMMs, higher frequencies, or non-ECC memory should look elsewhere. The kit is validated only for the listed Supermicro motherboard and its DDR5 5600 ECC specification.

Kohokohdat

  • ECC protection stops silent data corruption with on-the-fly single-bit error correction
  • 64 GB capacity delivered as two 32 GB modules for full dual-channel bandwidth
  • DDR5 5600 speed rated at PC5-44800 for high-throughput workloads
  • Low 1.10 V operation reduces power draw and thermal load
  • Verified fit for Supermicro X13SAW-F with 288-pin UDIMM form factor

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 ECC Unbuffered UDIMM Memory
Part NumberME44800-328K2
Capacity64GB (2 x 32GB)
Type288-Pin DDR5 ECC UDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC Unbuffered UDIMM Motherboard Compatible
Package Content64GB 2X32GB DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN ECC UDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Does the 64 GB kit include both 32 GB modules or do I need to buy a second kit?

The kit ships as a matched pair of two 32 GB modules, providing the full 64 GB in one package. No additional modules are required.

Is this the only DDR5 ECC UDIMM capacity offered for the Supermicro X13SAW-F?

This listing is for the 64 GB (2 x 32 GB) DDR5-5600 CL46 1.1 V kit. Other capacities or speeds would be separate products.

Will the DDR5-5600 CL46 rating run at that speed on the X13SAW-F without manual tuning?

The modules are spec-matched to the board's DDR5-5600 ECC requirements, so the memory controller should recognise the 5600 MT/s rating and CL46 timings automatically.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.