Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Four green DDR5 RDIMM modules without heat spreaders

NEMIX RAM

NEMIX RAM 64GB (4x16GB) DDR5 4800 CL40 1Rx8 ECC Registered RDIMM memory upgrade for GIGABYTE MZ33-AR1

SKU CH-9J1S-7FBC7

64GB DDR5-4800 ECC Registered RDIMM kit (4×16GB, CL40, 1.1V) validated for the GIGABYTE MZ33-AR1 motherboard

  • Capacity64GB (4 x 16GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 64GB 4X16GB

Näytä 18 muuta kokoonpanoa
  • 64 GB capacity from four 16 GB modules supports heavy server workloads
  • DDR5 4800 speed with CL40 latency delivers rated throughput for the platform
  • Registered ECC design corrects single-bit errors and stabilises fully populated slots
  • 1 V operation at 1Rx8 rank matches the motherboard memory controller exactly
  • 288-pin RDIMM form factor fits the GIGABYTE MZ33-AR1 without adapters

Exact-match upgrade kit

This 64 GB kit contains four 16 GB DDR5 RDIMMs rated at 4800 MT/s with CL40 latency and 1.1 V operation. The modules are registered and ECC-enabled, matching the memory controller expectations of the GIGABYTE MZ33-AR1 motherboard. Each stick uses a 1Rx8 organisation and a 288-pin form factor. The kit is new and ready for installation.

Registered ECC architecture

The registered design buffers address and command signals so the memory controller can drive all four slots at full population without signal degradation. On-die ECC corrects single-bit errors in real time, preventing silent data corruption and unplanned reboots in production workloads. This combination is required by the target platform for stable operation at rated speed.

Four-module population kit

The package delivers exactly four matched RDIMMs, allowing you to fill the board's supported channels in a single step. No heat spreaders are included, so airflow clearance follows the motherboard's standard DIMM spacing rules. Verify the manual for approved population order before installing to ensure the system recognises the full 64 GB capacity.

Kohokohdat

  • 64 GB capacity from four 16 GB modules supports heavy server workloads
  • DDR5 4800 speed with CL40 latency delivers rated throughput for the platform
  • Registered ECC design corrects single-bit errors and stabilises fully populated slots
  • 1 V operation at 1Rx8 rank matches the motherboard memory controller exactly
  • 288-pin RDIMM form factor fits the GIGABYTE MZ33-AR1 without adapters

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-618K4
Capacity64GB (4 x 16GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemGIGABYTE
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content64GB 4X16GB DDR5 4800MHz PC5-38400 1Rx8 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

What does the 4800 MT/s rating mean once the kit is installed in a GIGABYTE MZ33-AR1?

The memory controller will run all four 16 GB modules at DDR5-4800 (PC5-38400) with CL40 timing at 1.10 V, delivering the full 64 GB capacity at rated speed.

How does the registered ECC RDIMM interface affect operation on this motherboard?

The 288-pin registered design buffers address and command signals, letting the board run a fully populated 4-slot configuration at DDR5-4800 while ECC corrects single-bit errors on the fly.

What physical slot and clearance requirements does this 4-module kit have?

Each module is a standard 288-pin DDR5 RDIMM with no heat spreader, so it fits the four DIMM slots on the MZ33-AR1 following the board's population order.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.