Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

NEMIX RAM

NEMIX RAM 64GB 4x16GB DDR5 5600MHz CL46 1.1V ECC UDIMM memory upgrade

SKU CH-7NYJ-BWJ2A

A 64GB kit of four 16GB DDR5 5600MHz CL46 ECC UDIMM modules at 1.1V for Supermicro X14SAE-F

  • Capacity64GB (4 x 16GB)
  • Type288-Pin DDR5 ECC UDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes
  • ECC corrects single-bit errors to prevent data corruption
  • 64 GB kit (4 × 16 GB) matches board population rules
  • DDR5 5600 MHz speed runs at rated performance
  • 1 V operation meets exact controller voltage requirement
  • 288-pin UDIMM form factor fits Supermicro X14SAE-F motherboard

64GB DDR5-5600 ECC UDIMM Kit

This 64GB kit contains four 16GB DDR5-5600 (PC5-44800) unbuffered ECC UDIMMs. Each module runs at 1.1V with CL46 latency and a 1Rx8 organisation. The 288-pin DIMMs are built with major OEM chips and have no heat spreader. The kit is validated for the Supermicro X14SAE-F motherboard.

Suited for ECC workstations; not for non-ECC boards

The kit targets systems that require unbuffered ECC memory for error correction and data integrity. Builders whose motherboards accept only registered DIMMs or SODIMMs cannot use these modules. Systems that do not support ECC will not gain the error-correcting benefit. Buyers needing capacities beyond 64GB should verify their board's maximum supported memory first.

64GB capacity with DDR5-5600 headroom

Four ranks of 16GB provide 64GB of addressable memory for multi-threaded workloads, virtualisation and large datasets. The DDR5-5600 interface delivers PC5-44800 bandwidth at the rated voltage and latency. Workloads that exceed 64GB or demand higher frequencies will require a motherboard and processor combination qualified for larger kits or faster speeds.

Kohokohdat

  • ECC corrects single-bit errors to prevent data corruption
  • 64 GB kit (4 × 16 GB) matches board population rules
  • DDR5 5600 MHz speed runs at rated performance
  • 1 V operation meets exact controller voltage requirement
  • 288-pin UDIMM form factor fits Supermicro X14SAE-F motherboard

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 ECC Unbuffered UDIMM Memory
Part NumberME44800-618K4
Capacity64GB (4 x 16GB)
Type288-Pin DDR5 ECC UDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredUnbuffered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC Unbuffered UDIMM Motherboard Compatible
Package Content64GB 4X16GB DDR5 5600MHz PC5-44800 1Rx8 1.1V 288-PIN ECC UDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Does my motherboard need to accept 288-pin DDR5 ECC UDIMM modules for this kit to work?

Yes, the kit uses 288-pin DDR5 ECC unbuffered UDIMMs that must be supported by the motherboard.

Can I mix these 1Rx8 CL46 modules with existing DDR5 ECC UDIMMs that have a different rank or latency?

Mixing different ranks or CAS latencies can prevent the system from booting or force all modules to run at the slowest settings.

How do I confirm the full 64GB is recognised and ECC is active after installation?

Check the BIOS memory summary for 64GB total and ECC enabled, then run a memory test that reports ECC correction events.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.