Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green circuit board with black memory chips and gold edge connector

NEMIX RAM

NEMIX RAM 64GB DDR5 4800MHz CL40 2Rx4 1.1V 288-Pin ECC Registered RDIMM GIGABYTE MZ73-LM1 memory upgrade

SKU CH-0PQM-A28HJ

64GB DDR5 4800MHz ECC Registered RDIMM with CL40 timing and 1.1V operation, validated for GIGABYTE MZ73-LM1 server motherboards

  • Capacity64GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 64GB

Näytä 18 muuta kokoonpanoa
  • 64 GB capacity lets you fully populate supported slots on the GIGABYTE MZ73-LM1 motherboard
  • DDR5-4800 (PC5-38400) speed matches the board's rated memory controller frequency
  • Registered ECC design with 2Rx4 rank offloads the controller and corrects single-bit errors on the fly
  • 1 V operation at CL40 timing meets the exact voltage and latency the platform expects
  • 288-pin RDIMM form factor fits the server motherboard's DIMM sockets without adapters

64GB DDR5-4800 Registered ECC RDIMM

This NEMIX RAM module delivers 64GB of DDR5-4800 memory in a 288-pin registered form factor. It operates at 1.10V with CL40 latency and 2Rx4 organisation. The registered design and on-die ECC provide the signal integrity and error correction required by the GIGABYTE MZ73-LM1 motherboard.

Sustained enterprise workloads

Registered buffering reduces electrical load on the memory controller, allowing every populated slot to run at the rated 4800 MT/s continuously. ECC corrects single-bit errors in real time, preventing silent data corruption during long compute runs or virtualisation tasks. The 1.10V operation keeps power draw predictable under full population.

Replaces slower or smaller DDR5 RDIMMs

Upgrading from lower-capacity or lower-speed registered DDR5 modules is worthwhile when the platform supports the full 64GB per slot at 4800 MT/s. The jump is not justified for systems limited to UDIMM or SODIMM form factors, or for boards that cannot address this density or rank configuration.

Kohokohdat

  • 64 GB capacity lets you fully populate supported slots on the GIGABYTE MZ73-LM1 motherboard
  • DDR5-4800 (PC5-38400) speed matches the board's rated memory controller frequency
  • Registered ECC design with 2Rx4 rank offloads the controller and corrects single-bit errors on the fly
  • 1 V operation at CL40 timing meets the exact voltage and latency the platform expects
  • 288-pin RDIMM form factor fits the server motherboard's DIMM sockets without adapters

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-924K1
Capacity64GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemGIGABYTE
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content64GB DDR5 4800MHz PC5-38400 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

How much power does a single 64 GB DDR5 4800 module draw at its rated 1.10 V?

Each stick operates at 1.10 V, the standard DDR5 voltage, so power draw scales with the 4800 MT/s data rate and CL40 timing rather than any elevated voltage.

What motherboard slot and memory type are required for this 288-pin RDIMM to be recognised?

The module needs a DDR5 RDIMM slot on a GIGABYTE MZ73-LM1 motherboard; UDIMM or SODIMM slots will not accept the 288-pin registered form factor.

Can I mix this 2Rx4 Registered ECC stick with older unbuffered non-ECC DDR5 DIMMs in the same server?

No — registered ECC and unbuffered non-ECC architectures cannot share a memory channel, so the system would fail to train or disable the mismatched slots.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.