NEMIX RAM MR38400-618K6 96GB (6x16GB) DDR5 4800 CL40 ECC RDIMM Supermicro H14SHM
- 96GB (6 x 16GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
NEMIX RAM
A 96GB DDR5 4800 CL40 2Rx4 1.1V registered ECC RDIMM built to the Supermicro H13SST-GC memory specification
Size 96GB
This 96GB DDR5-4800 RDIMM is built for the Supermicro H13SST-GC motherboard. It delivers registered ECC memory with 2Rx4 organisation and CL40 timing at 1.1V. The module meets the board's strict population rules so every slot runs at full rated capacity.
Registered architecture reduces electrical load on the memory controller during sustained workloads. ECC corrects single-bit errors on the fly to prevent silent data corruption. The 1.1V operating voltage keeps power draw low inside dense chassis.
No heat spreader is fitted, allowing tight DIMM spacing in populated servers. The kit contains a single 96GB module keyed for DDR5 RDIMM slots only. Verify your system manual for approved population order before installation.
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM Original Series Server Memory |
| Model | DDR5 ECC RDIMM Registered Server Memory |
| Part Number | MR38400-9624K1 |
| Capacity | 96GB |
| Type | 288-Pin DDR5 RDIMM |
| Speed | DDR5 4800 (PC5 38400) |
| CAS Latency | CL40 |
| Voltage | 1.10V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Heat Spreader | No |
| Compatible System | Supermicro |
| Features | DDR5 ECC RDIMM Motherboard Compatible |
| Package Content | 96GB DDR5 4800MHz PC5-38400 2Rx4 1.1V 288-PIN ECC RDIMM KIT |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Power down, open the chassis, and insert the 288-pin module into the DIMM slot specified by the motherboard manual for single-DIMM or multi-DIMM configurations; the step most often missed is following the exact slot-population order required for registered ECC memory to initialise at 4800 CL40.
No routine maintenance is required; ECC corrects single-bit errors automatically, and the module is covered by a lifetime replacement warranty if a hardware fault develops.
The memory controller's maximum supported capacity and ranked-population rules for the H13SST-GC will cap usable memory before the module's own 4800 CL40 rating becomes a bottleneck.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?