Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

NEMIX RAM

NEMIX RAM 96GB DDR5 5600 CL46 1.1V 2Rx4 ECC RDIMM memory upgrade

SKU CH-ZHSF-3F658

96GB DDR5 5600 ECC registered RDIMM with CL46 timing and 1.1V operation, validated for Supermicro X14SRA-T servers

  • Capacity96GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes
  • 96 GB capacity fits large server workloads
  • DDR5 5600 speed matches Supermicro X14SRA-T specs
  • CL46 latency with 1.10 V voltage meets controller expectations
  • 2Rx4 registered ECC design prevents silent data errors
  • 288-pin RDIMM form factor installs in approved slots

Exact-match DDR5 RDIMM upgrade

This 96GB DDR5 5600 module is built for servers that require registered ECC memory with a 2Rx4 rank structure. It fits the 288-pin RDIMM slots on the Supermicro X14SRA-T motherboard and operates at the standard 1.1V DDR5 voltage.

Sustained-load stability

Registered buffering reduces the electrical load on the memory controller so every slot can run fully populated at the rated 5600 MT/s without down-clocking. On-die ECC corrects single-bit errors in real time, preventing silent data corruption during continuous workloads.

Rank and voltage gate

The 2Rx4 organization and 1.1V operating point are the decisive specifications; boards that expect a different rank count or voltage will not recognise the module at full capacity. Verify your platform's qualified-vendor list before ordering.

Kohokohdat

  • 96 GB capacity fits large server workloads
  • DDR5 5600 speed matches Supermicro X14SRA-T specs
  • CL46 latency with 1.10 V voltage meets controller expectations
  • 2Rx4 registered ECC design prevents silent data errors
  • 288-pin RDIMM form factor installs in approved slots

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-9624K1
Capacity96GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content96GB DDR5 5600MHz PC5-44800 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Does the 1.1V DDR5 5600 RDIMM generate noticeable heat or fan noise when all slots are populated on a Supermicro X14SRA-T?

The module runs at the standard 1.1V DDR5 voltage with no heat spreader, so thermal output depends on chassis airflow and the motherboard's fan curves rather than the DIMM itself. Registered buffering keeps electrical load low even with every slot filled.

What must the motherboard provide for this 288-pin 2Rx4 ECC RDIMM to operate?

The board needs DDR5 RDIMM slots, a memory controller that accepts registered ECC modules, and BIOS support for 96GB 2Rx4 DIMMs at 5600 MT/s with CL46 timings. The Supermicro X14SRA-T meets those requirements.

Can this 5600 MT/s CL46 kit run alongside older DDR5 modules at a lower common speed in the same server?

Yes, the memory controller will negotiate the highest speed all installed DIMMs share. Mixing ranks or timings is supported but the system will run at the slowest module's rated frequency and loosest latency.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.