Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

NEMIX RAM

NEMIX RAM DDR4 ECC RDIMM 512GB (4x128GB) 3200MHz CL22 2Rx4 1.2V 288-Pin Registered Server Memory Upgrade

SKU CH-WTQ3-9DY6F

A 512GB kit of four 128GB DDR4 3200MHz CL22 registered ECC RDIMMs built for the Supermicro X12SPA-TF motherboard

  • Capacity512GB (4 x 128GB)
  • Type288-Pin DDR4 RDIMM
  • SpeedDDR4 3200 (PC4 25600)
  • CAS LatencyCL22
  • Voltage1.20V
  • ECCYes
  • 512 GB total capacity from four 128 GB modules
  • Registered ECC design corrects single-bit errors automatically
  • DDR4-3200 speed with CL22 latency at 1.2 V
  • 288-pin RDIMM form factor fits Supermicro X12SPA-TF
  • 2Rx4 rank organisation enables full-population stability

Kit Composition and Target System

This 512GB kit contains four 128GB DDR4 3200MHz RDIMM modules built for the Supermicro X12SPA-TF motherboard. Registered ECC architecture and 2Rx4 organisation let the board run fully populated at rated speed without down-clocking. It is intended for administrators who need maximum supported capacity in that specific platform. Buyers with consumer boards or workstations that accept only unbuffered UDIMMs cannot use these modules.

Upgrade Path and Fitment Check

The kit replaces any smaller RDIMM set that leaves slots empty or forces a lower memory clock. Moving to this exact-match configuration removes the bandwidth penalty of partial population and avoids the timing mismatches that cause boot failures. The jump is worth it when the workload demands the full 512GB ceiling and the motherboard manual confirms support for 128GB 2Rx4 registered DIMMs at 3200MHz. Systems limited to lower per-slot density or unbuffered memory will not accept this kit.

Capacity Headroom and Limits

Four ranks per channel at 3200MHz give ample bandwidth for large in-memory databases, virtualisation clusters and heavy compute nodes. The 512GB ceiling is reached only when all four slots are filled with these 128GB modules; adding more memory is impossible on this board. Workloads that exceed 512GB or require faster than DDR4-3200 transfer rates need a different platform.

Kohokohdat

  • 512 GB total capacity from four 128 GB modules
  • Registered ECC design corrects single-bit errors automatically
  • DDR4-3200 speed with CL22 latency at 1.2 V
  • 288-pin RDIMM form factor fits Supermicro X12SPA-TF
  • 2Rx4 rank organisation enables full-population stability

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR4 ECC RDIMM Registered Server Memory
Part NumberMR25600-724K4
Capacity512GB (4 x 128GB)
Type288-Pin DDR4 RDIMM
SpeedDDR4 3200 (PC4 25600)
CAS LatencyCL22
Voltage1.20V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR4 ECC RDIMM Motherboard Compatible
Package Content512GB 4X128GB DDR4 3200MHz PC4-25600 2Rx4 1.2V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Does this 288-pin DDR4 RDIMM kit fit the Supermicro X12SPA-TF motherboard slots?

Yes, the 4x128GB kit is verified for the Supermicro X12SPA-TF and uses the 288-pin registered form factor that board requires.

What population order should I follow when installing all four 128GB modules?

Install the modules in the exact slot sequence listed in the Supermicro X12SPA-TF manual; the board's population rules dictate which DIMM slots must be filled first for full 512GB recognition.

Will the registered ECC design and 1.2V operation require any special cooling or periodic replacement?

No extra cooling is needed as the modules have no heat spreader, and the registered ECC architecture with 1.2V operation is designed for continuous server duty without scheduled replacement.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.