Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Four green DDR5 RDIMM sticks without heat spreaders, 288-pin, 4x128GB kit

NEMIX RAM

NEMIX RAM DDR5 512GB 4x128GB 4800MHz CL40 1.1V ECC RDIMM Supermicro H13SSL-NT

SKU CH-VEWM-DNPDP

512GB registered ECC DDR5 kit with four 128GB modules at 4800MHz CL40 1.1V, validated for Supermicro H13SSL-NT motherboards

  • Capacity512GB (4 x 128GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 512GB 4X128GB

Näytä 24 muuta kokoonpanoa
  • 512 GB total capacity from four 128 GB modules for maximum server density
  • DDR5 4800 MT/s speed delivers high throughput for demanding workloads
  • Registered ECC architecture offloads the controller and corrects single-bit errors
  • CL40 latency at 1.1 V optimizes stability under full population
  • 288-pin RDIMM form factor matches Supermicro H13SSL-NT slot requirements

Exact-match DDR5-4800 RDIMM kit for Supermicro

This 512 GB kit contains four 128 GB DDR5 Registered ECC RDIMMs rated at 4800 MHz CL40 and 1.10 V. The 2Rx4 modules match the memory controller's rank, voltage and timing requirements so the board recognises full capacity and runs at rated speed.

Who this suits and who should look elsewhere

The kit is built for administrators upgrading or populating a Supermicro H13SSL-NT motherboard with validated Registered ECC memory. It is not for systems that accept only unbuffered UDIMMs or SODIMMs, nor for builds that require a heat spreader or non-ECC operation.

Build integration

The 288-pin RDIMM form factor fits the H13SSL-NT slots and the registered architecture offloads the controller to allow full population at rated speed. ECC corrects single-bit errors on the fly to prevent silent data corruption. Check the motherboard manual for supported capacities, approved DIMM population order and installation steps before fitting.

Kohokohdat

  • 512 GB total capacity from four 128 GB modules for maximum server density
  • DDR5 4800 MT/s speed delivers high throughput for demanding workloads
  • Registered ECC architecture offloads the controller and corrects single-bit errors
  • CL40 latency at 1.1 V optimizes stability under full population
  • 288-pin RDIMM form factor matches Supermicro H13SSL-NT slot requirements

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-724K4
Capacity512GB (4 x 128GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content512GB 4X128GB DDR5 4800MHz PC5-38400 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Does the Supermicro H13SSL-NT motherboard need to support 2Rx4 Registered ECC DDR5 RDIMMs for this kit to function?

Yes. This kit is 2Rx4 Registered ECC DDR5 RDIMM at 1.10V. The H13SSL-NT must accept that exact rank, voltage, and registered form factor to recognise all 512GB at DDR5-4800 CL40.

Can I mix these 2Rx4 DDR5 RDIMMs with other DDR5 RDIMMs of different rank or speed on the H13SSL-NT?

Mixing ranks or speeds is not recommended. The board's memory controller expects uniform 2Rx4 modules at 1.1V; mismatched DIMMs may force a lower common speed, reduce capacity, or prevent boot.

How do I verify the kit is running at DDR5-4800 CL40 1.1V with ECC active after installation?

Enter the BIOS or use a tool like dmidecode on Linux. Confirm each slot shows 128GB, 4800 MT/s, CL40, 1.1V, Registered ECC, and 2Rx4 organisation with zero correctable errors logged.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.