BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
NEMIX RAM
A 288 GB DDR5 registered ECC kit of six 48 GB modules running at 6400 MT/s with CL52 latency and 1.1 V for the Supermicro H14DSG-OM motherboard
This 288GB kit contains six 48GB DDR5 6400 RDIMMs built to the Supermicro H14DSG-OM memory controller specification. Registered ECC modules with 2Rx8 organisation and CL52 timing at 1.1V are recognised at full capacity and rated speed without manual tuning.
Registered architecture buffers the command bus so all slots run fully populated while ECC corrects single-bit errors on the fly. These mechanisms prevent silent data corruption and unplanned reboots in production workloads.
Modules use the standard DDR5 RDIMM connector required by the target motherboard, not UDIMM or SODIMM layouts. Population order and maximum supported capacity must be verified in the system manual before installation.
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM Original Series Server Memory |
| Model | DDR5 ECC RDIMM Registered Server Memory |
| Part Number | MR51200-4828K6 |
| Capacity | 288GB (6 x 48GB) |
| Type | 288-Pin DDR5 RDIMM |
| Speed | DDR5 6400 (PC5 51200) |
| CAS Latency | CL52 |
| Voltage | 1.10V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Heat Spreader | No |
| Compatible System | Supermicro |
| Features | DDR5 ECC RDIMM Motherboard Compatible |
| Package Content | 288GB 6X48GB DDR5 6400MHz PC5-51200 2Rx8 1.1V 288-PIN ECC RDIMM KIT |
The kit is built to the exact rank, voltage and timing the board expects so it is recognised at full capacity and rated speed on first boot; no firmware step is required.
With 1.10 V registered ECC modules the memory controller thermal ceiling is reached before the DIMMs themselves throttle, so sustained throughput is bounded by the platform not the memory.
At 1.1 V the complete 288 GB kit consumes only a few watts per module, adding minimal heat and no audible noise since the RDIMMs have no heat spreaders or fans.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?