Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Eight green DDR5 RDIMM modules in anti-static tray

NEMIX RAM

NEMIX RAM DDR5 ECC RDIMM 384GB 8x48GB 4800 CL40 1.1V 2Rx8 Supermicro H13DSH memory upgrade

SKU CH-HZTS-DKF7W

A 384 GB DDR5 registered ECC server memory kit with eight 48 GB modules at 4800 MT/s, CL40, 1.1 V, 2Rx8, 288-pin, validated for the Supermicro H13DSH motherboard

  • Capacity384GB (8 x 48GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 384GB 8X48GB

Näytä 30 muuta kokoonpanoa
  • 384 GB total capacity from eight 48 GB modules for maximum server density
  • DDR5-4800 speed with CL40 latency runs at rated frequency on Supermicro H13DSH
  • Registered ECC architecture corrects single-bit errors and supports full-slot population
  • 1 V operating voltage matches platform spec for stable enterprise workloads
  • 288-pin RDIMM form factor fits the board's required memory slots

Supermicro H13DSH Memory Kit

This 384GB kit contains eight 48GB DDR5 4800 RDIMMs built to the exact rank, voltage and timing the Supermicro H13DSH motherboard expects. Registered ECC architecture offloads the memory controller and corrects single-bit errors so fully populated slots run at rated speed without silent data corruption. The modules operate at 1.1V with CL40 latency and use 288-pin DDR5 form factor.

Suited For And Not Suited For

This kit suits administrators upgrading a Supermicro H13DSH to its maximum supported capacity with validated registered ECC modules. It does not suit builds that require unbuffered UDIMMs, SODIMM form factor, non-ECC memory or speeds above 4800MT/s. Systems needing fewer than eight slots or lower total capacity should select a smaller matched kit instead.

Deciding Specification

The registered ECC RDIMM format with 2Rx8 organisation at 1.1V CL40 is the single specification that determines compatibility. Only motherboards wired for 288-pin DDR5 registered DIMMs with this exact rank and timing will initialise all 384GB at DDR5-4800. Verify the board's qualified-vendor list before purchase.

Kohokohdat

  • 384 GB total capacity from eight 48 GB modules for maximum server density
  • DDR5-4800 speed with CL40 latency runs at rated frequency on Supermicro H13DSH
  • Registered ECC architecture corrects single-bit errors and supports full-slot population
  • 1 V operating voltage matches platform spec for stable enterprise workloads
  • 288-pin RDIMM form factor fits the board's required memory slots

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-4828K8
Capacity384GB (8 x 48GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content384GB 8X48GB DDR5 4800MHz PC5-38400 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

What is the maximum capacity the Supermicro H13DSH motherboard can recognise with this 8 x 48 GB kit installed?

The kit provides 384 GB across eight 48 GB modules, matching the board's DDR5 RDIMM population rules for full-capacity operation.

How warm do the modules run and what cooling do they need during continuous operation?

Modules operate at 1.10 V without heat spreaders; standard server chassis airflow is sufficient for sustained loads.

Which motherboard slot type and memory standard must the system already have for these DIMMs to work?

The system requires a Supermicro H13DSH motherboard with 288-pin DDR5 RDIMM slots supporting registered ECC memory.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.