BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
OWC
16 GB DDR4 2666 ECC UDIMM module for Synology RS4017xs+ and RS4021xs+ NAS
This 16GB DDR4 ECC UDIMM is validated for the Synology RS4017xs+ and RS4021xs+ platforms. It provides a single-module capacity increase for NAS, rackmount and NVR workloads that require error-correcting memory. The module follows the standard 288-pin unbuffered form factor. Builders needing non-ECC memory or a different pin count cannot use this part.
Operating at 1.2V, the module runs at the standard DDR4 voltage without a heat spreader. Passive cooling inside the chassis is sufficient for typical 2666MHz operation. Power draw scales with the 2Rx8 organisation and CL19 timing during sustained file-serving tasks. No active cooling or extra airflow is specified by the manufacturer.
JEDEC and RoHS compliance make the upgrade warranty-safe for the target RackStation models. Backward compatibility with 2133MHz and 2400MHz systems allows the same module to work in slower slots. The supplier’s advanced replacement programme and limited lifetime warranty include free technical support for installation questions. No software utilities or additional accessories are bundled.
| Brand | OWC |
|---|---|
| Part Number | 2E6D42R816GB |
| Capacity | 16GB (1 x 16GB) |
| Type | 288-Pin DDR4 ECC UDIMM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL19 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | Synology RackstationRS4017xs+ Synology RackstationRS4021xs+ |
Power down the NAS, open the chassis, align the notch on the 288-pin module with the slot key, press firmly until the retention clips click, then power on and verify the new 16GB appears in DSM — the step often missed is fully seating both clips so ECC initialisation succeeds.
No scheduled maintenance is required; the module has no heat spreader and runs at 1.2V, so only replace it if a memory test reports correctable ECC errors rising above threshold or if you need more than 16GB per slot.
The memory controller caps operation at 2666 MT/s CL19; sustained heavy use will hit bandwidth and latency limits of the DDR4 2666 specification before thermal throttling occurs on the unbuffered 2Rx8 module.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?