OWC 8S5D32R804GB 4GB DDR3 1066 CL7 2Rx8 1.5V SODIMM memory upgrade
- 4GB
- 204-Pin DDR3 Non-EC…
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
OWC
A 4 GB DDR3 SODIMM running at 1333 MHz CL9 for Dell Studio 1457, 1557, 1558, 1747 and XPS 1645 laptops
This 4GB DDR3 SODIMM is built for Dell Studio 1457, 1557, 1558, 1747 and XPS 1645 notebooks. It delivers a straightforward capacity increase for owners of those specific models who need more memory for everyday multitasking. The module follows the exact electrical and physical layout required by those systems.
The module runs at a standard 1.5V without a heat spreader, relying on the laptop's internal airflow. As an unbuffered non-ECC stick it draws minimal power and adds no audible noise during typical workloads. Operation stays within JEDEC limits for the platform.
The 204-pin DDR3 1333 PC3-10600 CL9 2Rx8 form factor is the single detail that determines compatibility. Only systems designed for this exact pin count, voltage and timing will accept the module. Buyers with other DDR generations or different pin layouts cannot use it.
| Brand | OWC |
|---|---|
| Part Number | 1S3D32R804GB |
| Capacity | 4GB |
| Type | 204-Pin DDR3 Non-ECC SODIMM |
| Speed | DDR3 1333 (PC3 10600) |
| CAS Latency | CL9 |
| Voltage | 1.5V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | Dell Studio 1457 Dell Studio 1557 Dell Studio 1558 Dell Studio 1747 Dell Studio XPS 1645 |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Power off the laptop, remove the battery if accessible, open the memory compartment, align the notch on the module with the slot key, insert firmly until the gold contacts are no longer visible, then press down until the side clips click into place.
No firmware updates are required for this JEDEC-standard DDR3 memory, and solid-state DRAM has no moving parts or scheduled replacement interval under normal use.
The module operates at the standard 1.5V without a heat spreader, so sustained heavy workloads may hit thermal throttling limits before bandwidth or latency ceilings are reached.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?