OWC 64GB DDR4 3200 ECC Registered RDIMM CL22 2Rx4 1.2V 288-pin 3R2D42R464GB
- 64GB
- 288-Pin DDR4 ECC RD…
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
OWC
64 GB DDR4 3200 ECC registered RDIMM for Gigabyte E252 and G242 servers
Yliviivatut versiot ovat olemassa, mutta niitä ei ole varastossa täällä.
This OWC module provides 64GB of DDR4 3200 memory in a single 288-pin registered DIMM. It is built for Gigabyte E252-P30, E252-P31, G242-P31, G242-P32 and G242-P33 servers and workstations that require ECC registered RAM. Standard desktop computers cannot use this module.
The module runs at 1.2V with a CAS latency of 22 and conforms to the PC4-25600 JEDEC standard. No heat spreader is fitted, so airflow in the server chassis handles cooling. Registered buffering adds a clock cycle but reduces electrical load on the memory controller.
The 2Rx4 registered design means this DIMM must not be combined with unbuffered or ECC load-reduced memory in the same system. It is backward compatible with 2133, 2400, 2666 and 2933MHz bus speeds, allowing use in older Gigabyte platforms that support those rates.
| Brand | OWC |
|---|---|
| Part Number | 3R2D42R464GB |
| Capacity | 64GB |
| Type | 288-Pin DDR4 ECC RDIMM |
| Speed | DDR4 3200 (PC4 25600) |
| CAS Latency | 22 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Heat Spreader | No |
| Compatible System | Gigabyte E252-P30 Gigabyte E252-P31 Gigabyte G242-P31 Gigabyte G242-P32 Gigabyte G242-P33 |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Power down, open the chassis, align the notch on the 288-pin module with the slot key, press firmly until both latches click, then verify in BIOS that ECC registered mode is active — skipping the BIOS check is the common miss.
No scheduled maintenance is required; the module has no heat spreader and runs at 1.2V, so only replace it if a memory test reports correctable ECC errors rising or a DIMM fails POST.
The registered buffer adds one clock cycle of latency, so sustained throughput tops out at the JEDEC 3200 MT/s rating; thermal throttling is unlikely at 1.2V without a spreader.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
No language matches that.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?