iDPRT
iDPRT SP460BT 203DPI Bluetooth USB Direct Thermal Label Printer Packaging Support
- 230 dpi
64,99 $
0.00084219BTC
Varastossa
PrintOxe
PrintOxe PLA like SILK Filament 4 Pack 1.75mm 1kg Each Green Red Yellow Blue +/-0.03mm
Four spools of 1.75 mm silk PLA in green, red, yellow and blue totalling 8.8 lb with ±0.03 mm accuracy
- TypeFilament
- High-gloss silk finish creates shiny prints
- Precise ±0.03 mm diameter ensures consistent extrusion
- Four colours included — green, red, yellow, blue
- Vacuum-sealed with desiccant protects against moisture
- 75 mm diameter fits popular 3D printers
Four-colour silk PLA filament pack
This set contains four 1 kg spools of 1.75 mm PLA filament in green, red, yellow and blue. The silk-formula material produces a high-gloss surface finish on printed parts. Total net weight across the pack is 8.8 lbs. Each spool is vacuum-sealed with desiccant to protect against moisture.
Low-warp printing with standard temperatures
The filament is made from 100 % new high-purity corn-starch-based PLA, giving minimal warping and shrinkage. Recommended nozzle temperature ranges from 200 °C to 220 °C (392 °F to 428 °F). Dimensional accuracy is held to ±0.03 mm, which reduces the risk of clogging or blistering during normal printing.
Consistent feed for long print jobs
Spool dimensions are 7.88 in diameter, 2.69 in width with a 2.20 in hub hole, fitting common printer holders. The tight tolerance and dry packaging help maintain steady extrusion over extended builds. Compatible with a wide range of popular desktop 3D printers.
Kohokohdat
- High-gloss silk finish creates shiny prints
- Precise ±0.03 mm diameter ensures consistent extrusion
- Four colours included — green, red, yellow, blue
- Vacuum-sealed with desiccant protects against moisture
- 75 mm diameter fits popular 3D printers
Tekniset tiedot
| Brand | PrintOxe |
|---|---|
| Model | PLA like SILK |
| Type | Filament |
Kysymyksiä tästä tuotteesta
How do I load the 1.75mm spool and avoid the common mistake?
Mount the spool on the holder, feed filament into the extruder, and preheat the nozzle to 200°C–220°C. The step users often miss is drying the vacuum-sealed spool if it absorbed moisture after opening.
What maintenance will the silk PLA need over time?
Keep unused spools in sealed bags with desiccant to prevent moisture uptake. Clean the nozzle between colour changes to avoid silk-particle buildup, and replace the PTFE tube if it shows wear from the slightly abrasive finish.
What limit appears first during long prints?
The +/-0.03mm diameter tolerance can cause occasional under-extrusion on very long runs, and the silk surface may highlight layer lines more than standard PLA.
Myös tällä osastolla
Asiakkaat vertailivat myös näitä
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
