Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Four green DDR3 ECC DIMMs with black chips and gold pins

SAMSUNG

SAMSUNG DDR3 1600 64GB (4 x 16GB) CL11 1.35V ECC 240-Pin memory upgrade

SKU CH-YSRE-C1HH0

A 64GB DDR3 ECC kit of four 16GB modules running at 1600MHz with CL11 latency and 1.35V operation

  • Capacity64GB (4 x 16GB)
  • Type240-Pin DDR3 SDRAM
  • SpeedDDR3 1600 (PC3 12800)
  • CAS LatencyCL11
  • Voltage1.35V
  • 64GB total capacity from four 16GB modules
  • DDR3 1600 speed rated at PC3 12800
  • Low 1.35V voltage reduces power draw
  • CL11 CAS latency for responsive timing
  • ECC support with 72-bit width for error correction

64GB DDR3 ECC kit for servers

This 64GB kit contains four 16GB DDR3 modules built for server and workstation platforms that require ECC protection. Each stick runs at 1600MHz with a CL11 latency and operates at the low 1.35V voltage level. The 240-pin unbuffered design fits standard DDR3 DIMM slots in compatible systems.

Low-voltage DDR3 thermals and power

The 1.35V operating voltage reduces power draw and heat output compared to standard 1.5V DDR3, helping keep server chassis temperatures lower under sustained loads. CL11 timing at 1600MHz delivers stable throughput without pushing voltage or frequency into noisy territory. ECC circuitry adds a small overhead but runs silently with no active cooling required.

Upgrades from smaller or non-ECC DDR3

This kit replaces lower-capacity DDR3 sets or non-ECC modules when data integrity and maximum slot population are needed. The jump is worth it for virtualisation hosts, database servers or long-running compute nodes that cannot tolerate silent data corruption. Systems limited to 1.5V-only memory controllers or registered DIMM slots cannot use these modules.

Kohokohdat

  • 64GB total capacity from four 16GB modules
  • DDR3 1600 speed rated at PC3 12800
  • Low 1.35V voltage reduces power draw
  • CL11 CAS latency for responsive timing
  • ECC support with 72-bit width for error correction

Tekniset tiedot

Capacity64GB (4 x 16GB)
Type240-Pin DDR3 SDRAM
SpeedDDR3 1600 (PC3 12800)
CAS LatencyCL11
Voltage1.35V

Kysymyksiä tästä tuotteesta

How do I install the 240-pin DDR3 modules and which orientation mistake should I avoid?

Align the notch on each 240-pin DDR3 module with the slot key, press straight down until both retention clips click, and do not force the module backwards — the notch is off-centre so it only fits one way.

What maintenance will the ECC DDR3 memory need over time?

No routine maintenance is required; the ECC function corrects single-bit errors automatically, and the modules only need replacement if the system logs uncorrectable errors or fails memory diagnostics.

What limit appears first during sustained load on the CL11 1.35V kit?

The CAS latency of CL11 at 1600 MHz sets the timing floor, so under continuous workloads the memory controller hits the latency ceiling before voltage or thermal limits become a factor.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.