SunnyStar Co., Ltd
SunnyStar Co., Ltd TYF350LJ01 70mm 12V 0.35A 3-pin blower CPU cooler
70 mm blower fan with ball bearing, 12 V 0.35 A 3-pin connector, 4.2 W power draw for projector or compact case cooling
- ColorBlack
- TypeFan only
- Fan Size70mm
- Bearing TypeBall
- Power Connector3 Pin
- Blower design directs airflow through tight spaces
- 70 mm frame fits compact chassis and projectors
- Ball bearing ensures durable continuous operation
- 12 V 0.35 A draws only 4.2 W power
- Three-pin connector enables speed monitoring control
Compact 70 mm blower fan
The SunnyStar TYF350LJ01 is a 70 mm square blower fan designed for tight enclosures such as DLP projectors and small-form-factor cases. It runs on 12 V and draws 0.35 A for 4.2 W of power through a 3-pin connector. Ball bearings provide consistent rotation in the black frame.
Suited for projector and slim-case cooling
This unit fits builders replacing a 7025-size blower in projector housings or compact chassis where a radial airflow pattern is required. It is not for systems that need a 4-pin PWM header or a larger mounting footprint. Buyers wanting temperature-controlled speed curves should look elsewhere.
3-pin fixed-voltage connector
The 3-pin power connector delivers constant 12 V supply without PWM signalling, so fan speed stays fixed unless the motherboard or controller supports voltage regulation. Verify that the target device accepts a 3-wire 70 mm blower with 7025 mounting centres before ordering.
Kohokohdat
- Blower design directs airflow through tight spaces
- 70 mm frame fits compact chassis and projectors
- Ball bearing ensures durable continuous operation
- 12 V 0.35 A draws only 4.2 W power
- Three-pin connector enables speed monitoring control
Tekniset tiedot
| Model | TYF350LJ01 |
|---|---|
| Color | Black |
| Type | Fan only |
| Fan Size | 70mm |
| Bearing Type | Ball |
| Power Connector | 3 Pin |
Kysymyksiä tästä tuotteesta
Will the 70mm blower fit a 70mm x 25mm mounting cut-out?
The fan measures 70mm square by 25mm thick, so it matches a standard 70mm x 25mm mounting pattern.
Which way does the 3-pin connector key align when plugging it into a 12V header?
The three-pin plug has a key tab that lines up with the header notch; press straight down until the latch clicks to avoid bent pins.
How often should the ball-bearing blower be cleaned to maintain 4.2W airflow?
Use compressed air to clear dust from the blower wheel and vents every six to twelve months; the sealed ball bearing needs no lubrication.
Myös tällä osastolla
Asiakkaat vertailivat myös näitä
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
ModMyMods
ModMyMods MOD-0002 3/8" ID x 1/2" OD Clear PVC Tubing DIY Cooling
- Clear
0,82 $
0.00001055BTC
Varastossa