Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Small black 40mm square case fan 10mm thick two wires

Zyvpee

Zyvpee KDE1204PFVX 40mm 12V 1.8W 2 Pin Maglev case fan

SKU CH-D9QD-R5XTW

A 40 mm Maglev case fan running below 1600 RPM at 12 V and 1.8 W with a 2-pin connector

  • TypeCase Fan
  • CompatibilityCPU Cooler
  • Bearing TypeMaglev
  • RPM<1600 RPM
  • Power Connector2 Pin
  • ColorBlack
  • Maglev bearing cuts friction for quieter operation
  • 12 V 1.8 W draw keeps power use low
  • 40 mm frame fits tight CPU-cooler spaces
  • 2-pin connector simplifies installation
  • Sub-1600 RPM speed balances airflow and noise

Zyvpee KDE1204PFVX 40 mm Maglev Fan

This 40 mm case fan runs on 12 V and draws 1.8 W through a two-pin connector. The Maglev bearing keeps noise low at speeds below 1600 RPM. Its 40 x 10 mm frame fits tight CPU cooler cut-outs and small-form-factor chassis.

Suits builds needing a compact 12 V replacement

Buyers who need PWM control, a three- or four-pin header, LED illumination, or a larger frame size should look elsewhere. The fixed two-wire design offers no speed signalling, so it cannot report RPM to the motherboard.

Key spec: 40 x 10 mm two-pin 12 V Maglev

This single combination of mounting footprint, voltage, connector and bearing decides whether the fan fits your cooler bracket and header. Verify those four points against your hardware before ordering.

Kohokohdat

  • Maglev bearing cuts friction for quieter operation
  • 12 V 1.8 W draw keeps power use low
  • 40 mm frame fits tight CPU-cooler spaces
  • 2-pin connector simplifies installation
  • Sub-1600 RPM speed balances airflow and noise

Tekniset tiedot

BrandZyvpee
SeriesKDE1204PFVX
ModelKDE1204PFVX
TypeCase Fan
CompatibilityCPU Cooler
Bearing TypeMaglev
RPM<1600 RPM
Power Connector2 Pin
ColorBlack
LEDNon-LED
Dimensions40*10MM

Kysymyksiä tästä tuotteesta

Does the maglev bearing in the Zyvpee KDE1204PFVX need lubrication or replacement over time?

Maglev bearings use magnetic levitation instead of physical contact, so there is no oil to dry out and no sleeve to wear down. The fan is rated for continuous operation without scheduled bearing maintenance.

What limits the airflow of this 40 mm fan when it runs continuously at 12 V?

The motor is specified at 1.8 W and the speed ceiling is below 1600 RPM, so the aerodynamic curve of the 40×10 mm frame becomes the bottleneck before the motor reaches its thermal limit.

How much noise and heat does the fan produce during all-day use?

At 1.8 W the motor generates very little waste heat, and the maglev design keeps acoustic output low even during continuous operation.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.