OWC 16GB DDR4 3200MHz CL22 1.2V 260pin SODIMM Alienware X17 R1
- 16GB
- 260-Pin DDR4 Non-EC…
אנחנו מקבלים תשלום בקריפטו — כך שמטבעות הקריפטו שברשותך יכולים לקנות ציוד אמיתי.שלם בקריפטו, קנה איתו ציוד אמיתי. משלוח חינם ומבוטח לכל העולם מעל 399 $. קרטונים ניטרליים וללא מיתוג, נשלחים מגרמניה.משלוח חינם ומבוטח מעל 399 $. השער שלך ננעל ל-30 דקות מרגע פתיחת הקופה.שער נעול ל-30 דקות. כל פריט אטום, המספר הסידורי שלו נבדק, והוא מכוסה באחריות ל-24 חודשים.אטום, באחריות ל-24 חודשים.
A-Tech
An 8 GB DDR3 1066 MHz registered ECC DIMM built to replace the Micron MT36JSZS1G72PY-1G1A1DD module
This A-Tech 8GB DDR3 module is a registered ECC DIMM built as a compatible replacement for the Micron MT36JSZS1G72PY-1G1A1DD. It targets administrators upgrading or repairing server and workstation platforms that require registered memory with error correction. The single 8GB stick delivers 1066MHz speed at the standard 1.5V DDR3 voltage.
The 240-pin RDIMM installs in DDR3 server boards that support registered, dual-rank 2Rx4 modules and PC3-8500 speeds. Because it is buffered, it reduces electrical load on the memory controller, allowing higher total capacity configurations than unbuffered alternatives. Verify your system's qualified-vendor list and maximum supported density per slot before ordering.
Operating at 1.50V, the module runs within normal DDR3 power limits for registered server memory. The registered buffer adds minimal overhead while improving signal integrity at full population. Typical airflow across the DIMM slots is sufficient for cooling; no special heatsink or active cooling is required for standard server chassis environments.
| Brand | A-Tech |
|---|---|
| Series | Compatible Replacement for Micron |
| Model | MT36JSZS1G72PY-1G1A1DD |
| Capacity | 8GB |
| Speed | DDR3 1066 (PC3 8500) |
| CAS Latency | CL3 |
| Voltage | 1.50V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Micron Chipset |
| Features | MT36JSZS1G72PY-1G1A1DD |
This single module supplies 8 GB of DDR3 ECC registered memory for server workloads.
It runs at standard 1.50 V DDR3 voltage, so heat and power draw stay within normal DDR3 registered DIMM limits.
A DDR3 240-pin registered DIMM slot with ECC support and a compatible server chipset are required.
גם במדף הזה
אותו מדף, אותה קופה — שמונה מטבעות קריפטו ונעילת שער ל-30 דקות.
באיזה מטבע משלמים, ובאיזה מטבע מוצגים המחירים.
נשלח מהארנק שלך בקופה
לתצוגה בלבד — הקטלוג מתומחר בדולר ארה״ב
לא נמצא מטבע מתאים.
בחר את השפה שבה האתר פונה אליך.
חדש כאן?
כבר יש לך חשבון?
אין כאן איפוס אוטומטי: החנות הזו לא שולחת אימייל, ולכן אין קישור חד-פעמי לבקש. השאר את הכתובת בחשבון, והיא תטופל ידנית.
הבקשה נקלטה
שום דבר לא בדרך לתיבת האימייל שלך — החנות הזו לא שולחת אימייל בכלל. מישהו אוסף את הבקשות האלה ידנית.
נזכרת בה?