A-Tech 4GB DDR4 2666 ECC SODIMM CL19 1Rx8 1.2V 260-Pin
- 4GB
- 260-Pin DDR4 SO-DIMM
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
A-Tech
Dual-channel 8 GB DDR3L ECC SODIMM kit runs at 1600 MHz with CL11 latency at 1.35 V for microservers and NAS
Capacity 8GB (2 x 4GB)
Speed DDR3L 1600 (PC3L 12800)
CAS Latency CL11
This kit provides two 4 GB unbuffered ECC SODIMM modules for laptops, microservers and NAS units that accept DDR3L 1600 memory. Dual-rank organisation and error-correcting code help maintain data integrity in workloads that cannot tolerate silent corruption. The 1.35 V JEDEC low-voltage rating also allows operation at 1.5 V where the platform requires it.
The 204-pin SO-DIMM form factor fits standard DDR3 SODIMM slots without adapters or height clearance issues. A matched pair enables dual-channel bandwidth on compatible controllers, and the absence of a heat spreader keeps the modules thin enough for tight mobile workstation chassis. Installation follows normal SODIMM seating procedure with no special tools required.
Running at 1.35 V reduces power draw and heat output compared with standard 1.5 V DDR3, helping small-form-factor systems stay within thermal limits during sustained loads. Unbuffered ECC adds minimal latency overhead while delivering single-bit error correction and multi-bit detection. The modules operate silently with no active cooling and draw only the power needed for the memory controller.
| Brand | A-Tech |
|---|---|
| Series | A-Tech DDR3 ECC SODIMM |
| Model | A-Tech 4GB 2Rx8 PC3L-12800 ECC SODIMM |
| Part Number | NE-SS-0598 |
| Capacity | 8GB (2 x 4GB) |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Multi-channel Kit | Dual Channel Kit |
| Heat Spreader | No |
| Features | ECC SODIMM |
| Recommend Use | AMD & Intel Compatible |
| Option | ECC SODIMM |
Druge verzije ovog modela
Ista obitelj, različita memorija, hladnjak ili frekvencija — usporedite prije kupnje.
Yes, the modules run at DDR3L 1600 (PC3L-12800) with CL11 latency at 1.35V; they are also rated to operate at 1.5V if the platform requires it.
Each 4GB module uses the standard 204-pin DDR3 SO-DIMM form factor, so the laptop or microserver must provide a 204-pin SO-DIMM socket.
Insert both modules into the matching-channel slots (usually same-coloured) until the side clips click; the common mistake is not pressing firmly enough to fully seat the contacts.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Nema odgovarajućeg jezika.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?