暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Two green DDR3L SODIMM sticks with gold contacts and black chips

A-Tech

A-Tech 8GB (2x4GB) DDR3L 1600 ECC SODIMM 204-Pin 1.35V 2Rx8

SKU CH-PM3T-XAKDP

Dual-channel 8 GB DDR3L ECC SODIMM kit runs at 1600 MHz with CL11 latency at 1.35 V for microservers and NAS

  • Capacity8GB (2 x 4GB)
  • Type204-Pin DDR3 SO-DIMM
  • SpeedDDR3L 1600 (PC3L 12800)
  • CAS LatencyCL11
  • Voltage1.35V
  • ECCYes

Capacity 8GB (2 x 4GB)

  • 8GB (2 x 4GB)
  • 4GB

Speed DDR3L 1600 (PC3L 12800)

CAS Latency CL11

  • ECC protection prevents data corruption in critical workloads
  • Dual-rank 2Rx8 organisation increases memory density per slot
  • Low-voltage 1.35V operation reduces power draw and heat
  • DDR3L 1600 speed with CL11 latency speeds up responsive multitasking
  • 204-pin SO-DIMM form factor fits compatible laptops and microservers

8 GB DDR3L ECC SODIMM kit

This kit provides two 4 GB unbuffered ECC SODIMM modules for laptops, microservers and NAS units that accept DDR3L 1600 memory. Dual-rank organisation and error-correcting code help maintain data integrity in workloads that cannot tolerate silent corruption. The 1.35 V JEDEC low-voltage rating also allows operation at 1.5 V where the platform requires it.

204-pin dual-channel layout

The 204-pin SO-DIMM form factor fits standard DDR3 SODIMM slots without adapters or height clearance issues. A matched pair enables dual-channel bandwidth on compatible controllers, and the absence of a heat spreader keeps the modules thin enough for tight mobile workstation chassis. Installation follows normal SODIMM seating procedure with no special tools required.

Low-voltage DDR3L thermals

Running at 1.35 V reduces power draw and heat output compared with standard 1.5 V DDR3, helping small-form-factor systems stay within thermal limits during sustained loads. Unbuffered ECC adds minimal latency overhead while delivering single-bit error correction and multi-bit detection. The modules operate silently with no active cooling and draw only the power needed for the memory controller.

特長

  • ECC protection prevents data corruption in critical workloads
  • Dual-rank 2Rx8 organisation increases memory density per slot
  • Low-voltage 1.35V operation reduces power draw and heat
  • DDR3L 1600 speed with CL11 latency speeds up responsive multitasking
  • 204-pin SO-DIMM form factor fits compatible laptops and microservers

仕様

BrandA-Tech
SeriesA-Tech DDR3 ECC SODIMM
ModelA-Tech 4GB 2Rx8 PC3L-12800 ECC SODIMM
Part NumberNE-SS-0598
Capacity8GB (2 x 4GB)
Type204-Pin DDR3 SO-DIMM
SpeedDDR3L 1600 (PC3L 12800)
CAS LatencyCL11
Voltage1.35V
ECCYes
Buffered/RegisteredUnbuffered
Multi-channel KitDual Channel Kit
Heat SpreaderNo
FeaturesECC SODIMM
Recommend UseAMD & Intel Compatible
OptionECC SODIMM

このモデルの他のバージョン

同シリーズにさらに 5点

同じファミリーで、メモリ・クーラー・クロックが異なります — 購入前に比較してください。

この商品に関する質問

Does the DDR3L 1600 interface operate at PC3L-12800 speeds when installed in a system that only supports DDR3 1600?

Yes, the modules run at DDR3L 1600 (PC3L-12800) with CL11 latency at 1.35V; they are also rated to operate at 1.5V if the platform requires it.

What physical slot and pin count does this 204-pin SO-DIMM kit require?

Each 4GB module uses the standard 204-pin DDR3 SO-DIMM form factor, so the laptop or microserver must provide a 204-pin SO-DIMM socket.

How are the two modules installed for dual-channel operation, and what step is often missed?

Insert both modules into the matching-channel slots (usually same-coloured) until the side clips click; the common mistake is not pressing firmly enough to fully seat the contacts.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。