A-Tech 4GB DDR4 2666 ECC SODIMM CL19 1Rx8 1.2V 260-Pin
- 4GB
- 260-Pin DDR4 SO-DIMM
Vi tager imod kryptovaluta — så den krypto, du ejer, kan købe rigtig hardware.Betal med krypto, brug det på rigtig hardware. Gratis, forsikret levering til hele verden ved køb over 399 $. Neutrale, umærkede papkasser, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Din kurs låses i 30 minutter, så snart kassen åbner.Kurs låst i 30 minutter. Hver vare er forseglet, har kontrolleret serienummer og er dækket af 24 måneders garanti.Forseglet, 24 måneders garanti.
A-Tech
Dual-channel 8 GB DDR3L ECC SODIMM kit runs at 1600 MHz with CL11 latency at 1.35 V for microservers and NAS
Capacity 8GB (2 x 4GB)
Speed DDR3L 1600 (PC3L 12800)
CAS Latency CL11
This kit provides two 4 GB unbuffered ECC SODIMM modules for laptops, microservers and NAS units that accept DDR3L 1600 memory. Dual-rank organisation and error-correcting code help maintain data integrity in workloads that cannot tolerate silent corruption. The 1.35 V JEDEC low-voltage rating also allows operation at 1.5 V where the platform requires it.
The 204-pin SO-DIMM form factor fits standard DDR3 SODIMM slots without adapters or height clearance issues. A matched pair enables dual-channel bandwidth on compatible controllers, and the absence of a heat spreader keeps the modules thin enough for tight mobile workstation chassis. Installation follows normal SODIMM seating procedure with no special tools required.
Running at 1.35 V reduces power draw and heat output compared with standard 1.5 V DDR3, helping small-form-factor systems stay within thermal limits during sustained loads. Unbuffered ECC adds minimal latency overhead while delivering single-bit error correction and multi-bit detection. The modules operate silently with no active cooling and draw only the power needed for the memory controller.
| Brand | A-Tech |
|---|---|
| Series | A-Tech DDR3 ECC SODIMM |
| Model | A-Tech 4GB 2Rx8 PC3L-12800 ECC SODIMM |
| Part Number | NE-SS-0598 |
| Capacity | 8GB (2 x 4GB) |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Multi-channel Kit | Dual Channel Kit |
| Heat Spreader | No |
| Features | ECC SODIMM |
| Recommend Use | AMD & Intel Compatible |
| Option | ECC SODIMM |
Andre versioner af denne model
Samme familie, men med anden hukommelse, køler eller clockfrekvens — sammenlign, før du bestemmer dig.
Yes, the modules run at DDR3L 1600 (PC3L-12800) with CL11 latency at 1.35V; they are also rated to operate at 1.5V if the platform requires it.
Each 4GB module uses the standard 204-pin DDR3 SO-DIMM form factor, so the laptop or microserver must provide a 204-pin SO-DIMM socket.
Insert both modules into the matching-channel slots (usually same-coloured) until the side clips click; the common mistake is not pressing firmly enough to fully seat the contacts.
Også på denne hylde
Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.
Det du betaler med, og det du ser priserne i.
Sendes fra din tegnebog i kassen
Kun til visning — kataloget er prissat i USD
Ingen valuta matcher det.
Vælg det sprog, siden taler til dig på.
Ny her?
Har du allerede en?
Der findes ingen automatisk nulstilling: denne butik sender ingen e-mails, så der er intet engangslink at bede om. Efterlad adressen på kontoen, så bliver den behandlet manuelt.
Anmodning registreret
Der er intet på vej til din indbakke — denne butik sender slet ingen e-mails. Nogen behandler dem manuelt.
Kom du i tanke om den?