NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
A-Tech
8GB DDR3L 1600 ECC RDIMM 2Rx4 at 1.35V for server and workstation upgrades
This 8GB DDR3L 1600 module is a registered ECC DIMM built for server and workstation systems that require error-correcting memory. It runs at 1.35V low voltage with CL11 latency and a 2Rx4 organisation. The 240-pin form factor fits standard DDR3 server slots.
Administrators upgrading compatible platforms with validated DDR3L registered ECC memory will find this a direct match. Systems that need unbuffered DIMMs, higher frequencies, or non-ECC modules cannot use this part.
The module combines ECC error correction and register buffering in a dual-rank x4 configuration. This specific organisation is required by many server memory controllers for stable operation at full population.
| Brand | A-Tech |
|---|---|
| Capacity | 8GB |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
CL11 is the rated latency for this DDR3L 1600 module; the registered buffer and ECC logic add a cycle, but the limit under sustained use is the memory controller's maximum supported frequency and rank population rules, not the CAS figure alone.
At 1.35 V the DDR3L module draws less power than standard 1.5 V DDR3, reducing heat output; the registered driver adds slight consumption, but total thermal load stays within normal server DIMM limits for continuous operation.
A 240-pin DDR3 DIMM slot wired for registered ECC memory and a chipset or CPU memory controller that validates DDR3L 1.35 V 2Rx4 modules are required; consumer boards without registered-ECC support will not post.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?