NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
A-Tech
8GB DDR3L 1600 ECC RDIMM 2Rx4 at 1.35V for server and workstation upgrades
This 8GB DDR3L 1600 module is a registered ECC DIMM built for server and workstation systems that require error-correcting memory. It runs at 1.35V low voltage with CL11 latency and a 2Rx4 organisation. The 240-pin form factor fits standard DDR3 server slots.
Administrators upgrading compatible platforms with validated DDR3L registered ECC memory will find this a direct match. Systems that need unbuffered DIMMs, higher frequencies, or non-ECC modules cannot use this part.
The module combines ECC error correction and register buffering in a dual-rank x4 configuration. This specific organisation is required by many server memory controllers for stable operation at full population.
| Brand | A-Tech |
|---|---|
| Capacity | 8GB |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
CL11 is the rated latency for this DDR3L 1600 module; the registered buffer and ECC logic add a cycle, but the limit under sustained use is the memory controller's maximum supported frequency and rank population rules, not the CAS figure alone.
At 1.35 V the DDR3L module draws less power than standard 1.5 V DDR3, reducing heat output; the registered driver adds slight consumption, but total thermal load stays within normal server DIMM limits for continuous operation.
A 240-pin DDR3 DIMM slot wired for registered ECC memory and a chipset or CPU memory controller that validates DDR3L 1.35 V 2Rx4 modules are required; consumer boards without registered-ECC support will not post.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?