NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Wij accepteren cryptovaluta — zo kunnen de munten die u bezit echte hardware kopen.Betaal in crypto, besteed het aan echte hardware. Gratis verzekerde verzending wereldwijd vanaf $399. Neutrale dozen zonder merk, verzonden vanuit Duitsland.Gratis verzekerde verzending vanaf $399. Uw koers wordt 30 minuten vastgezet zodra het afrekenen begint.Koers 30 minuten vastgezet. Elk artikel is verzegeld, het serienummer wordt gecontroleerd, en het valt onder 24 maanden garantie.Verzegeld, 24 maanden garantie.
A-Tech
8GB DDR3L 1600 ECC RDIMM 2Rx4 at 1.35V for server and workstation upgrades
This 8GB DDR3L 1600 module is a registered ECC DIMM built for server and workstation systems that require error-correcting memory. It runs at 1.35V low voltage with CL11 latency and a 2Rx4 organisation. The 240-pin form factor fits standard DDR3 server slots.
Administrators upgrading compatible platforms with validated DDR3L registered ECC memory will find this a direct match. Systems that need unbuffered DIMMs, higher frequencies, or non-ECC modules cannot use this part.
The module combines ECC error correction and register buffering in a dual-rank x4 configuration. This specific organisation is required by many server memory controllers for stable operation at full population.
| Brand | A-Tech |
|---|---|
| Capacity | 8GB |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
CL11 is the rated latency for this DDR3L 1600 module; the registered buffer and ECC logic add a cycle, but the limit under sustained use is the memory controller's maximum supported frequency and rank population rules, not the CAS figure alone.
At 1.35 V the DDR3L module draws less power than standard 1.5 V DDR3, reducing heat output; the registered driver adds slight consumption, but total thermal load stays within normal server DIMM limits for continuous operation.
A 240-pin DDR3 DIMM slot wired for registered ECC memory and a chipset or CPU memory controller that validates DDR3L 1.35 V 2Rx4 modules are required; consumer boards without registered-ECC support will not post.
Ook in deze afdeling
Dezelfde afdeling, dezelfde kassa — acht munten en een koers die 30 minuten vaststaat.
Waarmee u betaalt, en waarin u de prijzen leest.
Verzonden vanuit uw wallet bij het afrekenen
Alleen ter weergave — de catalogus is geprijsd in USD
Geen valuta gevonden.
Kies de taal waarin de site met u spreekt.
Nieuw hier?
Al een account?
Er is geen automatisch herstel: deze winkel verstuurt geen e-mail, dus er is geen eenmalige link om aan te vragen. Laat het adres op het account achter en het wordt handmatig opgepakt.
Verzoek genoteerd
Er is niets onderweg naar uw inbox — deze winkel verstuurt helemaal geen e-mail. Iemand pakt dit handmatig op.
Weet u het weer?