NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.
A-Tech
8GB DDR3L 1600 ECC RDIMM 2Rx4 at 1.35V for server and workstation upgrades
This 8GB DDR3L 1600 module is a registered ECC DIMM built for server and workstation systems that require error-correcting memory. It runs at 1.35V low voltage with CL11 latency and a 2Rx4 organisation. The 240-pin form factor fits standard DDR3 server slots.
Administrators upgrading compatible platforms with validated DDR3L registered ECC memory will find this a direct match. Systems that need unbuffered DIMMs, higher frequencies, or non-ECC modules cannot use this part.
The module combines ECC error correction and register buffering in a dual-rank x4 configuration. This specific organisation is required by many server memory controllers for stable operation at full population.
| Brand | A-Tech |
|---|---|
| Capacity | 8GB |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
CL11 is the rated latency for this DDR3L 1600 module; the registered buffer and ECC logic add a cycle, but the limit under sustained use is the memory controller's maximum supported frequency and rank population rules, not the CAS figure alone.
At 1.35 V the DDR3L module draws less power than standard 1.5 V DDR3, reducing heat output; the registered driver adds slight consumption, but total thermal load stays within normal server DIMM limits for continuous operation.
A 240-pin DDR3 DIMM slot wired for registered ECC memory and a chipset or CPU memory controller that validates DDR3L 1.35 V 2Rx4 modules are required; consumer boards without registered-ECC support will not post.
Aj v tomto oddelení
Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.
Mena, v ktorej platíte, a mena, v ktorej sa zobrazujú ceny.
Odoslané z vašej peňaženky na pokladni
Len na zobrazenie — katalóg je uvedený v dolároch
Žiadna mena nezodpovedá.
Vyberte jazyk, v ktorom s vami bude web komunikovať.
Ste tu prvýkrát?
Účet už máte?
Automatický reset hesla neexistuje: tento obchod neposiela žiadne e-maily, takže neexistuje jednorazový odkaz, o ktorý by ste mohli požiadať. Nechajte adresu na účte — niekto sa jej ujme ručne.
Žiadosť zaznamenaná
Do vašej schránky nič nepríde — tento obchod neposiela vôbec žiadne e-maily. Niekto sa o to postará ručne.
Spomenuli ste si?