EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
Computer Memory Solutions
16 GB dual-channel DDR3L 1600 SO-DIMM kit validated for Dell Optiplex 9030 All-In-One
This 16GB kit contains two 8GB SO-DIMM modules built specifically for the Dell Optiplex 9030 All-In-One. Each stick uses 204-pin DDR3L technology running at 1600MHz with CL11 timings. The unbuffered, non-ECC design matches the system's original memory architecture for direct compatibility.
The modules operate at a reduced 1.35V compared to standard DDR3, lowering heat output during extended workloads. CL11 latency with 11-11-11 timing provides stable data access for typical office applications and multitasking. The 2Rx8 rank organisation supports the platform's dual-channel memory controller without requiring active cooling.
Installation requires placing both modules into the system's two available SO-DIMM slots to reach the 16GB maximum. No heat spreaders are fitted, so clearance inside the slim All-In-One chassis is not an issue. Builders needing more than 16GB or a different memory generation cannot use this kit.
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM10246412800SODRL |
| Capacity | 64MB |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Timing | 11-11-11 |
| Voltage | 1.35V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Dell Optiplex 9030 All-In-One |
| Package Content | 2 Memory RAM Sticks |
The kit runs at 1.35 volts, which is the standard low-voltage DDR3L level, so power draw and heat output stay low even under continuous load in the OptiPlex 9030 All-In-One.
The system needs two free SODIMM slots that accept 204-pin DDR3L modules; the 9030 All-In-One ships with two sockets, so the kit fills the board completely.
The modules are rated CL11 at 1600MHz; if existing sticks share the same voltage and speed the system will run all memory at the common supported rate.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Nema odgovarajućeg jezika.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?