EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
Wij accepteren cryptovaluta — zo kunnen de munten die u bezit echte hardware kopen.Betaal in crypto, besteed het aan echte hardware. Gratis verzekerde verzending wereldwijd vanaf $399. Neutrale dozen zonder merk, verzonden vanuit Duitsland.Gratis verzekerde verzending vanaf $399. Uw koers wordt 30 minuten vastgezet zodra het afrekenen begint.Koers 30 minuten vastgezet. Elk artikel is verzegeld, het serienummer wordt gecontroleerd, en het valt onder 24 maanden garantie.Verzegeld, 24 maanden garantie.
Computer Memory Solutions
16 GB dual-channel DDR3L 1600 SO-DIMM kit validated for Dell Optiplex 9030 All-In-One
This 16GB kit contains two 8GB SO-DIMM modules built specifically for the Dell Optiplex 9030 All-In-One. Each stick uses 204-pin DDR3L technology running at 1600MHz with CL11 timings. The unbuffered, non-ECC design matches the system's original memory architecture for direct compatibility.
The modules operate at a reduced 1.35V compared to standard DDR3, lowering heat output during extended workloads. CL11 latency with 11-11-11 timing provides stable data access for typical office applications and multitasking. The 2Rx8 rank organisation supports the platform's dual-channel memory controller without requiring active cooling.
Installation requires placing both modules into the system's two available SO-DIMM slots to reach the 16GB maximum. No heat spreaders are fitted, so clearance inside the slim All-In-One chassis is not an issue. Builders needing more than 16GB or a different memory generation cannot use this kit.
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM10246412800SODRL |
| Capacity | 64MB |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Timing | 11-11-11 |
| Voltage | 1.35V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Dell Optiplex 9030 All-In-One |
| Package Content | 2 Memory RAM Sticks |
The kit runs at 1.35 volts, which is the standard low-voltage DDR3L level, so power draw and heat output stay low even under continuous load in the OptiPlex 9030 All-In-One.
The system needs two free SODIMM slots that accept 204-pin DDR3L modules; the 9030 All-In-One ships with two sockets, so the kit fills the board completely.
The modules are rated CL11 at 1600MHz; if existing sticks share the same voltage and speed the system will run all memory at the common supported rate.
Ook in deze afdeling
Dezelfde afdeling, dezelfde kassa — acht munten en een koers die 30 minuten vaststaat.
Waarmee u betaalt, en waarin u de prijzen leest.
Verzonden vanuit uw wallet bij het afrekenen
Alleen ter weergave — de catalogus is geprijsd in USD
Geen valuta gevonden.
Kies de taal waarin de site met u spreekt.
Geen taal gevonden.
Nieuw hier?
Al een account?
Er is geen automatisch herstel: deze winkel verstuurt geen e-mail, dus er is geen eenmalige link om aan te vragen. Laat het adres op het account achter en het wordt handmatig opgepakt.
Verzoek genoteerd
Er is niets onderweg naar uw inbox — deze winkel verstuurt helemaal geen e-mail. Iemand pakt dit handmatig op.
Weet u het weer?