Computer Memory Solutions
Computer Memory Solutions 16GB (2x8GB) DDR3L 1600 SO-DIMM memory upgrade for Dell Optiplex 9030 All-In-One
16 GB dual-channel DDR3L 1600 SO-DIMM kit validated for Dell Optiplex 9030 All-In-One
- Capacity64MB
- Type204-Pin DDR3 SO-DIMM
- SpeedDDR3L 1600 (PC3L 12800)
- CAS LatencyCL11
- Timing11-11-11
- Voltage1.35V
- 16 GB total capacity in a matched 2 x 8 GB kit
- DDR3L 1600 MHz speed rated at PC3L 12800
- Low 1.35 V operation reduces power draw
- CL11 11-11-11 timing for responsive access
- Validated for Dell Optiplex 9030 All-In-One systems
Targeted 16GB DDR3L kit for Dell Optiplex 9030
This 16GB kit contains two 8GB SO-DIMM modules built specifically for the Dell Optiplex 9030 All-In-One. Each stick uses 204-pin DDR3L technology running at 1600MHz with CL11 timings. The unbuffered, non-ECC design matches the system's original memory architecture for direct compatibility.
Sustained operation at 1.35V low voltage
The modules operate at a reduced 1.35V compared to standard DDR3, lowering heat output during extended workloads. CL11 latency with 11-11-11 timing provides stable data access for typical office applications and multitasking. The 2Rx8 rank organisation supports the platform's dual-channel memory controller without requiring active cooling.
Straightforward slot installation
Installation requires placing both modules into the system's two available SO-DIMM slots to reach the 16GB maximum. No heat spreaders are fitted, so clearance inside the slim All-In-One chassis is not an issue. Builders needing more than 16GB or a different memory generation cannot use this kit.
Pontos fortes
- 16 GB total capacity in a matched 2 x 8 GB kit
- DDR3L 1600 MHz speed rated at PC3L 12800
- Low 1.35 V operation reduces power draw
- CL11 11-11-11 timing for responsive access
- Validated for Dell Optiplex 9030 All-In-One systems
Especificações
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM10246412800SODRL |
| Capacity | 64MB |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Timing | 11-11-11 |
| Voltage | 1.35V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Dell Optiplex 9030 All-In-One |
| Package Content | 2 Memory RAM Sticks |
Perguntas sobre este artigo
How much heat and power do the 1.35V DDR3L 1600 modules draw during all-day use?
The kit runs at 1.35 volts, which is the standard low-voltage DDR3L level, so power draw and heat output stay low even under continuous load in the OptiPlex 9030 All-In-One.
What must the Dell OptiPlex 9030 All-In-One already have for this 2x8GB 204-pin kit to install?
The system needs two free SODIMM slots that accept 204-pin DDR3L modules; the 9030 All-In-One ships with two sockets, so the kit fills the board completely.
Will the CL11 1600MHz timing work alongside any original memory left in the OptiPlex 9030 All-In-One?
The modules are rated CL11 at 1600MHz; if existing sticks share the same voltage and speed the system will run all memory at the common supported rate.
Também nesta secção
Os clientes também compararam
Mesma prateleira, mesma finalização da compra — oito moedas e uma taxa bloqueada durante 30 minutos.



