EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.
Computer Memory Solutions
16 GB dual-channel DDR3L 1600 SO-DIMM kit validated for Dell Optiplex 9030 All-In-One
This 16GB kit contains two 8GB SO-DIMM modules built specifically for the Dell Optiplex 9030 All-In-One. Each stick uses 204-pin DDR3L technology running at 1600MHz with CL11 timings. The unbuffered, non-ECC design matches the system's original memory architecture for direct compatibility.
The modules operate at a reduced 1.35V compared to standard DDR3, lowering heat output during extended workloads. CL11 latency with 11-11-11 timing provides stable data access for typical office applications and multitasking. The 2Rx8 rank organisation supports the platform's dual-channel memory controller without requiring active cooling.
Installation requires placing both modules into the system's two available SO-DIMM slots to reach the 16GB maximum. No heat spreaders are fitted, so clearance inside the slim All-In-One chassis is not an issue. Builders needing more than 16GB or a different memory generation cannot use this kit.
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM10246412800SODRL |
| Capacity | 64MB |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Timing | 11-11-11 |
| Voltage | 1.35V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Dell Optiplex 9030 All-In-One |
| Package Content | 2 Memory RAM Sticks |
The kit runs at 1.35 volts, which is the standard low-voltage DDR3L level, so power draw and heat output stay low even under continuous load in the OptiPlex 9030 All-In-One.
The system needs two free SODIMM slots that accept 204-pin DDR3L modules; the 9030 All-In-One ships with two sockets, so the kit fills the board completely.
The modules are rated CL11 at 1600MHz; if existing sticks share the same voltage and speed the system will run all memory at the common supported rate.
Også i denne avdelingen
Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.
Det du betaler med, og det du ser prisene i.
Sendes fra lommeboken din i kassen
Kun visning — katalogen er prissatt i USD
Fant ingen valuta.
Velg språket nettstedet snakker til deg på.
Ingen språk samsvarer.
Ny her?
Har du allerede en konto?
Det finnes ingen automatisk tilbakestilling: butikken sender ikke e-post, så det finnes ingen engangslenke å be om. La adressen stå på kontoen, så blir den behandlet manuelt.
Forespørsel registrert
Ingenting er på vei til innboksen din — butikken sender ingen e-post i det hele tatt. Noen behandler dette manuelt.
Husket du det likevel?