EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
Computer Memory Solutions
Dual-channel 4 GB DDR2-667 ECC kit validated for Intel S3200SH, S3210SH, SE7230CA1-E and SE7230NH1-E servers
This 4 GB kit contains two 2 GB DDR2 modules built for Intel S3200SH, S3210SH, SE7230CA1-E and SE7230NH1-E servers. ECC protection and unregistered operation match the platform requirements exactly. It is not for desktops, workstations or any system that needs registered DIMMs or a different DDR generation.
Each module runs at the standard 1.8 V DDR2 voltage with no heat spreader, so power draw stays low in normal server workloads. Passive cooling from chassis airflow is sufficient; no extra fan or active cooling is required. Noise remains at the level of the existing system fans.
The two sticks fill two of the four available slots and raise total memory toward the 8 GB platform maximum. ECC capability lets the server detect and correct single-bit errors, improving data integrity for always-on workloads. No software or drivers are included; the modules are ready to install and recognised by the system BIOS.
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM256725300ECCNRDR |
| Capacity | 4GB (2 x 2GB) |
| Type | 240-Pin DDR2 SDRAM |
| Speed | DDR2 667 (PC2 5300) |
| CAS Latency | CL5 |
| Timing | 5-5-5 |
| Voltage | 1.8V |
| ECC | Yes |
| Buffered/Registered | Unregistered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Intel S3200Sh, S3210Sh, Se7230Ca1-E, Se7230Nh1-E |
| Package Content | 2 Memory RAM Sticks |
Power down the server, open the chassis, align each module's notch with the slot key, and press firmly until both retention clips click; the step often missed is seating both modules in the correct channel pair so the board recognises the full 4 GB.
No routine maintenance is required; if a module fails the ECC logic will report corrected errors in the system log, at which point the faulty stick should be replaced with an identical 2 GB DDR2 667 CL5 1.8 V 2Rx8 DIMM.
The platform's maximum of 8 GB across four sockets is reached with two of these kits, so capacity is the first ceiling; bandwidth is capped at the DDR2 667 data rate and CL5 latency.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
No language matches that.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?