OWC 16GB DDR4 3200MHz CL22 1.2V 260pin SODIMM Alienware X17 R1
- 16GB
- 260-Pin DDR4 Non-EC…
Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.
Computer Memory Solutions
Dual-channel 4 GB DDR2-667 ECC kit validated for Intel S3200SH, S3210SH, SE7230CA1-E and SE7230NH1-E servers
This 4 GB kit contains two 2 GB DDR2 modules built for Intel S3200SH, S3210SH, SE7230CA1-E and SE7230NH1-E servers. ECC protection and unregistered operation match the platform requirements exactly. It is not for desktops, workstations or any system that needs registered DIMMs or a different DDR generation.
Each module runs at the standard 1.8 V DDR2 voltage with no heat spreader, so power draw stays low in normal server workloads. Passive cooling from chassis airflow is sufficient; no extra fan or active cooling is required. Noise remains at the level of the existing system fans.
The two sticks fill two of the four available slots and raise total memory toward the 8 GB platform maximum. ECC capability lets the server detect and correct single-bit errors, improving data integrity for always-on workloads. No software or drivers are included; the modules are ready to install and recognised by the system BIOS.
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM256725300ECCNRDR |
| Capacity | 4GB (2 x 2GB) |
| Type | 240-Pin DDR2 SDRAM |
| Speed | DDR2 667 (PC2 5300) |
| CAS Latency | CL5 |
| Timing | 5-5-5 |
| Voltage | 1.8V |
| ECC | Yes |
| Buffered/Registered | Unregistered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Intel S3200Sh, S3210Sh, Se7230Ca1-E, Se7230Nh1-E |
| Package Content | 2 Memory RAM Sticks |
Power down the server, open the chassis, align each module's notch with the slot key, and press firmly until both retention clips click; the step often missed is seating both modules in the correct channel pair so the board recognises the full 4 GB.
No routine maintenance is required; if a module fails the ECC logic will report corrected errors in the system log, at which point the faulty stick should be replaced with an identical 2 GB DDR2 667 CL5 1.8 V 2Rx8 DIMM.
The platform's maximum of 8 GB across four sockets is reached with two of these kits, so capacity is the first ceiling; bandwidth is capped at the DDR2 667 data rate and CL5 latency.
Einnig í þessum vöruflokki
Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.
Það sem þú greiðir í, og það sem þú sérð verð í.
Sent úr veskinu þínu í greiðsluferlinu
Aðeins til skýringar — verð í vörulistanum eru í Bandaríkjadölum
Enginn gjaldmiðill passar við það.
Veldu tungumálið sem síðan talar við þig á.
Fyrsta heimsókn?
Áttu þegar aðgang?
Það er engin sjálfvirk endurstilling: þessi verslun sendir engan tölvupóst, svo það er enginn einnota tengill til að biðja um. Skildu netfangið eftir á aðganginum og einhver sinnir því handvirkt.
Beiðni skráð
Ekkert er á leiðinni í pósthólfið þitt — þessi verslun sendir engan tölvupóst. Einhver sinnir þessu handvirkt.
Mundir þú það?